MACOM AMC-132SMA, AM-132PIN Datasheet

High Performance Amplifier,
10 dB Gain, 5 - 200 MHz

V 4.00

AM-/AMC-132

Features

n +49 dBm Typical Midband Third Order Intercept
n +29 dBm Typical Midband 1 dB Compression
n 4.5 dB Typical Midband Noise Figure

Description

M/A-COM’s AM-132 is a coupler feedback amplifier with
high intercept and compression points. The use of coupler
feedback minimizes noise figure and current in a high
intercept amplifier. This amplifier is packaged in a flatpack
with flanges. Due to the internal power dissipation the
thermal rise should be minimized. The ground plane on the
PC board should be configured to remove heat from under
the package. AM-132 is ideally suited for use where a high
intercept, high reliability amplifier is required.

C-25

FP-8

Absolute Maximum Ratings 1

Parameter Absolute Maximum

Max. Input Power +15 dBm

V

+17.0 V

bias

Operating Temperature -55°C to +85°C

Storage Temperature -65°C to +125°C

1. Operation of this device above any one of these
parameters may cause permanent damange.

Pin Configuration

Pin # Function Pin # Function

1 RF OUT 6 RF IN
2 GND 7 GND
3 GND 8 GND
4 GND 9 GND
5 Vbias 10 GND

High Performance Amplifier, 10 dB Gain, 5 - 200 MHz

Electrical Specifications2 TA = -55°C to +85°C Case Temperature

Parameter Test Conditions Frequency Units Min. Typ. Max.

Gain 50 MHz @ +25°C 50 MHz dB 9.5 10.0 10.5

Frequency Response — 5 - 200 MHz dB — — ±0.5

AM-/AMC-132

V 4.00

Gain Variation with

— 5 - 200 MHz dB — — ±0.6

Temperature

1 dB Compression Output Power 5 - 200 MHz dBm +25 — —

Noise Figure — 5 - 200 MHz dB — — 6.0

Reverse Transmission — 5 - 200 MHz dB — -14 -13

VSWR — 5 - 200 MHz Ratio — — 1.5:1

Output IP2 Two-tone inputs up to +10 dBm 5 - 200 MHz dBm

Output IP3 Two-tone inputs up to +10 dBm 5 - 200 MHz

5 - 70 MHz

dBm
dBm

+54 —

—

+38
+45

—
—

—
—

—
—

Vbias — — V 14.25 15 15.75

Ibias Vbias = +15.0 VDC — mA — 90 110

Power Dissipation @ +15V Bias — W — 1.35 —

2. All specifications apply when operated at +15 VDC, with 50 ohms source and load impedance.

3. Heat Sinking: Operation at case temperature above 95°C is not recommended. Heat sinking adequate to dissipate 1.75W must
be provided in use.

Typical Performance Curves

Gain vs. Frequency

+85°C +25°C -55°C

11.0

10.5

Gain (dB)

10.0

9.5
3 5 10 20 50 100 200 300

Frequency (MHz)

Specifications subject to change without notice.

n

North America: Tel. [phone]

n Asia/Pacific: Tel.[phone], Fax [phone]
n

Europe: Tel. [phone], Fax[phone]

Visit www.macom.com for additional data sheets and product information.

Intermodulation Intercept

IP2IP3

68

66

64

62

Intercept (dBm)IP2

60

3 5 10 20 50 100 200 300

Frequency (MHz)

52

50

48

46

Intercept (dBm) IP3

44

2