MacKissic LB552PNM, LB862M, 77181, 77151 Owner’s Manual

LEAF BLOWER

7f77/S/ gt77/g /

LBSS2PNM - LB862M

OWNER'S MANUAL

NOTICE

FAMILIARIZE YOURSELF WITH THE CAUTION

!NSTRUCTIONS BELOW BEFORE PROCEEDING

TO READ THE INSTRUCTION MANUAL•

IMPROPER OPERATION CAN CAUSE SERIOUS INJURY.

_., _JNNBNNJN_IIIrDBAIVE,aWmAIIVEAIIFNNXm,41r XNXN_

ih CAUTION/h

• tl) READOP_RA11NGII_RUCITO_S 1HOFI_IGIIY 8_RE tJ_MG. _3)NEVERope_e v_ k p_lecJvecoverromove_ (6) S_Pengineandd_N_'14x2sperkrY_u9vJ_et)eioreaIM_9 •

4k el=pedap==d imu aMl_=Dt _ audn =nwaeg. _ myim.,,._ _klm, _-ar,lm_. _ kmr,_ a_ im_o p

091-O058

"L ._•

091-0059

610/495-7181

MACKISSIC, INC. P.O. BOX 111, PARKER FORD, PA 19457

e-mail [e-mail]

FORM NO. LB552PNM*862M-O6/99

FAX [phone]

P/N 7(750154

Assembly Instructions

Your leaf blower has been carefully packed at the factory. Before proceeding with assembly, make sure all parts

have been received and are in good condition. If there are shortages or damage, report it immediately to the
company from whom you obtained the machine.

NOTE: In the following instructions, the item number refers to

the number encircled forthat part on the drawing.

1. Insert the upper handle into the lower square tube handle. There are three holes in each side of the
upper handle which serve as height adjustment holes. Position the upper handle at a comfortable

height for you (usually waist high). Move the upper handle up or down slightly to align the holes in

the upper and lower handles. Assemble the handle bar brace, placing the top holes of the brace on
the upper handle and the lower holes on the lower handle. Space with washers as shown in the

drawing. Tighten securely.

2. For 8 hp units, align the wheel hole with the front bracket hole and slide the 1/2" Dia. shoulder bolt

through. Tighten with the 3/8-16 Nylon Locknut while being careful not to overtighten by checking
that the wheel turns freely.

Note: The front wheel bracket (item 34) provides two different discharge height adjustments by

turning the bracket over. The total discharge height adjustment is 1-1/4".

3. Engine is shipped WITHOUT OIL. Fill crankcase with oil before starting.

4. Service the engine as recommended by the manufacturer. Fill the fuel tank with fresh gasoline.

5. Familiarize yourself with the operating instructions before attempting to use your blower.

Training and Preparation/Safety Precautions

• Become familiar with the owner's manual before attempting to operate this machine.

• Children should not be allowed to operate this equipment.

• Before starting the leaf blower, check that all screws, nuts, bolts,and other fasteners are properly secured.

• NEVER direct the discharge air stream toward any observers, children, pets or fragile objects. Small stones,
twigs, or grit can be thrown with sufficient force to cause injury or damage.

• NEVER start the engine or use your blower without the impeller cover mounted in place. Do NOT put any
objects like sticks or fingers in holes of impeller cover.

• While running your leaf blower, operators should NOT allow hands or any other part of the body or loose fitting

clothing near the rotating impeller which can cause injury.