Macaw Sound Technology TX80 User Manual

User Guide

Bluetooth Headset

Trade Mark: MacaW

Model: TX80

Manufacturer: Macaw Sound Technology Co., Ltd.

Address: NO.203, Second Floor of HuaMei Mansion, HuaMei Road, SongGang Street, BaoAn District, ShenZhen, China

Operation

Power on：Press and hold down the power button till a blue light appears

Power off：Press and hold down the power button till a red light appears

Paring：Press and hold down the power button 6~8 seconds till red and blue light flashing

Volume adjust: Press the volume + to increase volume or Volume - to decrease the volume

Music track choose：Press and hold Volume - to select previous track, and Volume + to select the next track.

Pause/play: When the bluetooth headset is connected with mobile phone, press the power button once to play music,

press power button quickly to pause the music.

Answering/ending the call：Press the power button once to answering or end the call

Reject calling：Press the power button 1 seconds

LED instruction

Charging：Red LED when charing, after full charge, blue LED

Paired：Blue Led flashing slow

Paring：Red and blue LED flashing alternate

FCC Statement:

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the

FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential

installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to

radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try

to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to

operate this equipment.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device

may not cause harmful interference, and (2) this device must accept any interference received, including interference that

may cause undesired operation.

The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure

condition without restriction.