Lyyt LR30 User Manual

LR30

RGB Amplifier/Repeater

Item ref: 153.774UK

User Manual

153.774UK User Manual

Caution: Please read this manual carefully before operating

Damage caused by misuse is not covered by the warranty

Introduction

The LR30 is a signal repeater designed to allow extended runs of 12V or 24V RGB LED tape
and strip. Any RGB LED tape controller has a limited amount of current capacity, which means
that it can only control a limited length of LED tape. The LR30 acts as a signal repeater or
amplifier so that further lengths of tape can be added to the controlled “incoming” length of
tape and all colours will be repeated across both tapes.

Setting up

 Connect the Blue, Red, Green and Voltage+ connections at the end of the incoming

tape to the B, R, G and + screw terminals labeled “INPUT”

 Connect the Blue, Red, Green and Voltage+ connections at the beginning of the

continuation tape to the B, R, G and + screw terminals labeled “OUTPUT”

 Connect an appropriate DC power supply for the LED tapes (either 12V or 24V) to the

screw terminals labelled “POWER”

1. POWER 12Vdc or 24Vdc power supply connection

2. OUTPUT Blue, Red, Green and Voltage+ connections to continuation LED tape

3. INPUT Blue, Red, Green and Voltage+ connections from incoming LED tape