Page 1
PARTS INCLUDED IN KIT:
RIGHT HAND SIDE EXTENSION (QTY 1)
LEFT HAND SIDE EXTENSION (QTY 1)
REAR FRAME PIECE (QTY 1)
SCREW, #8-32 X 3/8 PHILLUPS TRUSS HEAD (QTY 2)
P/N 33596 P.1
Page 2
3-1/2"
ADAPTOR KIT FOR LYNX 27",30",36",42",54" GRILLS
22" to 25-1/2" (27",36")
24-1/2" to 28"
LIAK27
LIAK30
LIAK36
LIAK42
LIAK54
(FITS ISLAND CUTOUT SIZES SHOWN BELOW)
INSTALLATION INSTRUCTIONS
1) AFTER COMPLETE ASSEMBLY (PAGE 1)
PLACE LYNX ISLAND ADAPTOR FRAME
DIRECTILY OVER ISLAND CUTOUT. PLACE
FRONT EDGES OF SIDE EXTENSIONS FLUSH
WITH FRONT OF ISLAND FACE. CENTER
FRAME LEFT TO RIGHT OVER ISLAND
CUTOUT.
2) SLIDE GRILL IN FROM FRONT, OR
LOWER GRILL FROM TOP, INTO ISLAND
CUTOUT AND OVER LYNX ADAPTOR
FRAME. ALLOW THE OUTER FLANGES OF
THE GRILL TO SEAT OUTSIDE OF THE
VERTICLE FLANGES OF THE ADAPTOR
FRAME. (THE ADAPTOR FRAME VERTICLE
FLANGES WILL BE CONCEALED BY THE
(30",42",54")
BASE OF THE GRILL).
2"
2" HOLE
(27" GRILL)- 25-1/4" to 26-1/2"
(30" GRILL)- 28-5/8" to 29-1/2"
(36" GRILL)- 34-1/4" to 35-1/2"
(42" GRILL) -40-1/4" to 41-1/2"
(54" GRILL) -52-1/4" to 53-1/2"
10" to 11"
5-1/2"
7-5/8"
NOTE: IF EXISTING ISLAND CUTOUT
IS EXACTLY THE MINIMUM DIMENSION
SHOWN (FOR WIDTH), THEN A SMALL
RELIEF NEEDS TO BE CUT IN THE FRONT
VERTICAL EDGES OF THE ISLAND
(BOTH SIDES) APPROX. 1" BACK FROM
THE FRONT.
IMPORTANT NOTE: THIS KIT IS ONLY TO BE USED WITH NON-COMBUSTIBLE ISLAND SURFACES.
PLEASE REFER TO THE LYNX CARE AND USE MAUNAL, ACCOMPANING THE GRILL, FOR PROPER
RANCES WHEN MOUNTING INTO COMBUSTIBLE ISLAND MATERIALS.
CLEA
P/N 33596 P.2
1-5/8"
1"
1/4"
Loading...