Lynx LCB23LP Installation Manual

LCB2-3 INSTALLATION INSTRUCTIONS

TOOLS REQUIRED: 7/16 Wrench
CONTENTS OF KIT: An adjustable side burner mounting bracket
Side shelf mounting bracket with 7/16 fasteners
Decorative cover for the L27 and L36 models

P/N 34912. 8/14

INSTRUCTIONS FOR MODELS L36 and L27:

1. Remove the right hand side shelf and the cabinet back panel (fig. 1)

2. Mount the LCB2-3 side burner to the supports (fig. 2)

3. If needed, any misalignment can be corrected by 1st measuring the amount of misalignment, 2nd loosening the
bracket support fasteners. 3rd raise or lower the bracket according to your measurements.
Tighten the fasteners. (fig 3)

4. Hang the side shelf removed in step 1 on the right side shelf support pins of the side burner (Fig. 6, pg. 2)

The side burner support bracket comes preassembled for the L27 and L36

1

Rear View

2

3

Lynx Grills, 7300 Flores St., Downey, CA 90242
Customer Care Ph.: 888-289-5969/ Fax: [phone]/[e-mail]
P/N 34912 8/14

INSTRUCTIONS FOR MODELS L54, L42, L30:

1. Remove the right hand side shelf. See fig.1 on page 1

2. At the rear, remove the decorative cover (1) on the left hand side of the LCB2-3 by removing the Philips head screw
and sliding it out. This also gives access to the gas piping connections. (Fig. 2)

3. Locate the mounting bracket on the inner most bracket support (Fig 3). Remove the 7/16 fasteners holding it in
place Reinstall the mounting bracket on the rear most bracket support and secure it with the 7/16 fasteners

4. As in step 3 on page 1,correct any misalignment in the shelf

5. Move the shelf mounting bracket on the right hand side, to the outermost mounting holes using the 7/16 nuts, and
tighten. (Fig. 5)

6. Hang the side shelf removed in step 1, pg. 1 to the right side of side burner on the shelf mounting bracket pins
(Fig 6)

Remove the bracket from the inside

3

support and install it onto the outer

support

2

5

This bracket must be mounted in the outer

position

6