Lynx LAK User Manual

LAK Installation Instructions

3.

Locate the receptacle on the back right side of the accessory that has two simple leads. Make the

Lynx Electrical Adapter Kit

Introduction:

These instructions `detail the electrical connections between Series L and later Lynx Grills and Accessories to
older grills for the following accessories:

LSB1 Single Side Burner
LSB2 Double Side Burner

Each kit contains two wire assemblies and a transformer. Only one wire assembly will be used depending on
the units being installed. Only the conversion for the Grills before Series L requires the transformer.

Identifying the model year .

All gas burning grills and accessories have a unique serial number to identify each product.
The serial number contains two numbers followed by two letters followed by 5 or more additional numbers.
Older Model year Newer Model year

S/N: 96KL91016 S/N: 03LN91016

LAK Installation – Series L and later Grills to a prior model Series Accessory:

1. Disconnect the transformer lead From the Grill.

2. Attach the adapter wire assembly to the transformer and grill shown as (A) and (B) in the diagram.

connection to the plug shown as (C) in the diagram. DO NOT confuse this with the receptacle shown as
“X” in the diagram. The connector with 4 wire leads will not be used.

4. The last connection is the receptacle on the adapter to the 2 pin plug on the wire lead from the
accessory.

LPB Power Burner
LSB2PC Prep Center

LSBGE Grill Extender

A

C

B

D

Series J-K

Lynx Accessory

Lynx Grills, Inc. | 6023 E. Bandini Blvd. Commerce, CA 90040 | Phone: (323)838‐1770 Fax: (323)838‐1778 | www.lynxgrills.com
PN: 33194 Rev C 05/02/11

Series L+

Lynx Grill

Precautions while working on electrical connections:

C

Read and understand the instruction manuals provided with both the grill and accessory being installed.
Review these instructions in their entirety before beginning.

TURN OFF ALL GAS AT IT’S SOURCE to the appliances BEFORE beginning any electrical work. When working on
an island installation, open any doors or drawers and allow the space to ventilate before beginning any work.
Unplug the transformer from it’s receptacle under the island.

LAK Installation – Series L and later Accessory to a prior model Series Grill:

1. Disconnect the transformer lead labeled 1700mA and 500mA. This transformer will no longer be used.

2. Attach the two joined leads from the harness shown as (A) in the diagram. Note that this lead has
two, 2-pin connectors (one male one female). DO NOT confuse this with the receptacle shown as (C).

3. Attach the 4-pin receptacle from this harness to the plug from the accessory shown

as (B) in the diagram.

4. Locate the plug on the back right side of the Grill that is labeled TO ACCESSORY. Make the connection to

the receptacle shown as (C) in the diagram.

5. The last connection is the 4 pin plug on the adapter to the 4 pin receptacle on the wire lead from the

transformer into the accessory shown as (D) in the diagram.

D

B

A

Connector identification:

4 pin PLUG 4 pin RECEPTACLE

Lynx Grills, Inc. | 6023 E. Bandini Blvd. Commerce, CA 90040 | Phone: (323)838‐1770 Fax: (323)838‐1778 | www.lynxgrills.com
PN: 33194 Rev C 05/02/11

2 pin PLUG

2 pin RECEPTACLE

Pg 2