LY International Electronics M-2588 User Manual

Public Address System

Remote Paging Selector M-2588

M-2588

Remote Paging Selector

LEVEL(dBV)

+30-3-8-13

∞

CALL ALL

User's Manual

Welcome to use our public address system. Please read this manual carefully before using this device for your
better use.

LY I n t e rn a t i o n a l El e c t r oni c s C o . , L t d .

http：//www.lyintlcorp.com

About this Manual

This Manual is used since the date when the development of intelligent remote paging selector is

completed. The manual contains the system introduction, precautions, system connection

instruction, product use instruction, product specification and so on. Please read this manual

carefully before installation and use of the device. Follow the instructions in the manual.

All instructions marked with this symbol on the rear panel of the machine are precautions.
Please ensure follow them strictly.

Please keep this manual carefully for future reference.

Warning

The following basic requirements must be strictly observed, to avoid potential personal injury and

equipment or property damages to you or any person nearby. The basic requirements include without

limitation to the following:

Power source/power cable

• Please disconnect the device from power source by
pulling the plug other than the power cord. Pulling the
power cord may result in damages.

• Please keep the power cord away from heat source.
Do not overbend the power cord or place it anywhere
it can be stepped on or may cause to trip.

• This is connected to power source via the plug and
any failure or danger occurs, the user can disconnect
the device from power source by pulling out the plug
out from the socket, therefore, it is required that the
power socket should be located somewhere with easy
access.

• The device is not completely disconnected from
power source when it is switched "OFF". For sake of
safety, please disconnect the device from the socket if
it is not in user.

Positioning

• Please disconnect the device from power source
before relocating the device.

• For avoiding deformation of panels and damages to
internal components, please do NOT place the device
where there is heavy dust or violent vibration, or
where it is extremely cold or hot.

• Please keep this device off water drops or splash or
vase filled with water or any other articles of similar
nature.

Connection

• Please disconnect other equipment from power
source before they are connected to this product.
Please tune volume to its minimum level before the
device is powered ON or OFF.

• All terminals on the device marked with

are live
and dangerous, and should be connected by trained
personnel.

When abnormal conditions are realized

• Please disconnect the device from power source

immediately in case the power cord is worn or
damaged or if the sound is suddenly cut off or any
abnormal odor or smoke comes out from the device,
and then have the device inspected and repaired by
professional personnel.

Precautions in Operation

• Please do NOT insert any finger into any gap or
opening of the device.

• Please prevent foreign objects (paper, plastics or
metal etc.) from being inserted or falling into any gap
or opening of the device. In such case, please cut off
power source immediately.

• Please do NOT put the body or any heavy object on
the device and do NOT operate the buttons or
switches or connections with excessive force.

Do NOT open

• Please do NOT remove the cover of the equipment,
otherwise you may get an electric shock.

• Do NOT attempt to remove any internal component
from the device, or to modify the equipment in
whatever manner. In case of any abnormal condition,
please stop using the device immediately and have it
inspected and repaired by professional personnel.

Other Precautions

• Our company shall not be responsible for data loss
or damages due to improper use of unauthorized
modification to the device.

• The images and screen display in this Manual are
only for description and may be different from
screen images in actual operation. The screen
display depends on the product.

Contents

I. Introduction ............................................................................................................................................................. 1

1.1 Introduction to the device ............................................................................................................................. 1

1.2 Features ........................................................................................................................................................ 1

II. Outline ................................................................................................................................................................... 1

2.1 Front Side ..................................................................................................................................................... 2

2.2 Back side .................................................................................................................................................. 3

III. Connection Diagram .........................................................................................................

3.1 Schematic diagram of M-2588 system ......................................................................................................... 4

3.2 Connection of local interface of M-2588 paging selector .......................................................................... 4

IV． Operating instructions ...................................................................................................................................... 5

4.1 Start ............................................................................................................................................................ 5

4.2 Description of main menu .......................................................................................................................... 6

4.2.1 Display of time state .................................................................................................................................. 6

4.2.2 Partition status display ............................................................................................................................... 6

4.2.3 Partition paging operation ......................................................................................................................... 6

4.2.4 Grouping state display ............................................................................................................................... 7

4.2.5 Grouping Paging Operation ....................................................................................................................... 7

4.2.6 Other operations ........................................................................................................................................ 8

4.3 System Setting .............................................................................................................................................. 8

4.3.1 Time Setting .............................................................................................................................................. 8

4.3.2 User Information ..................................................................................................................................... 9

4.3.3Backlighttime ........................................................................................................................................... 10

4.3.4 Microphone setting .................................................................................................................................. 10

4.3.5 Bell setting ............................................................................................................................................... 10

V.Matters need attentions .......................................................................................................

VI． Packing List .................................................................................................................................................... 11

VII． Performance Specification ............................................................................................................................ 11

Fire control/public address system paging selector

Remote paging selector M-2588

1

I. Introduction

1.1 Introduction to the device

M-2588 series of remote paging selectors have the feature of high stability as traditional ones, and it operates

stably with low failure rate. It adopts signal all-digital transmission design, and the intelligent control as the

core. 7-inch LCD true color LCD screen/touch screen control and graphics and texts interfaces are more

user-friendly. With auxiliary input and output channels, it can achieve local audio expansion and amplifier

expansion.

1.2 Features

 7-inch true color touch screen, high-grade aluminum alloy industrial drawing panel design.
 Desktop design.
 High-fidelity and hand-held dynamic microphone design.
 Possess multi-level level indication, and the sound pressure is more intuitive.
 Convenience for quick paging in emergencies with manual shortcut keys.
 Possess one line input (extended external program source, wireless microphone access, etc.), one local line

output (local output off-line paging), and one auxiliary line output (extended monitoring power).

 Graphic user-friendly design, more intuitive display.
 Embedded real-time system platform, high-performance ARM processor.
 Built-in bell sound.
 Paging function of the host partition.
 User password and privilege management.
 With automatic intelligent microphone-off function, you can see turn off paging time delay by the speaker.
 Manually turn on and turn off the paging microphone power supply.
 With intelligent screen protection function, you can set the color display screen protection delay time.

