Lx Flarm Eagle Mobile User Manual

User’s manual

version 1.0

Copyright © 2019, LX navigation, all rights reserved.

Made in Slovenia.

SMA FLARM

Optional

USB port

Power/mode button

LED indicators

Quick Guide

Congratulations for purchasing the LX FLARM Eagle

mobile. Please congure the LX FLARM Eagle mobile
prior to rst use. Set your ICAO 24-bit address, aircra

type and transponder conguration (chapter 1.2).

1. Power ON/OFF

parameters of the display (baudrate and hierarchy).
Power OFF the unit, press PWR/MODE button and hold to
power ON and continue holding for 4 seconds.
The display parameter indication will change (see

table below) aer each press on mode selector for

approximately 2 seconds. To change the selected
parameter, press PWR/MODE short - the status will
indicate circular LED’s.

To Power ON the device press the PWR/MODE button.
Once the unit gets GPS signal it will be operable. To
Power OFF the device press and hold the PWR/MODE

button until the lights go o.

1.2. Display settings

Using of PWR/MODE button it is possible to adjust some

Parameter
Twin conf.
Baudrate

LED

Tx
Tx+Rx

LED 18°

PIC
4800 bps

LED 54°

PAX
9600 bps

Note: Default baudrate of LX Flarm Eagle mobile is set to
19200 bps. Please check and set to correct Baudrate in
case of communication problems.

1. Installation

Find the ideal spot in your cocpit to install the device.
Connect the FLARM RF antenna according to FTD-041

LED 90°

19200 bps

LED 126°

--------------

LED 162°

38400 bps

LED 198°

57600 bps