Luxor|H.Wilson WPSMS20CH User Manual

Stationary LCD TV Stand Instructions

09/05/13

www.luxorfurn.com
www.hwilson.com

A x1 B x1D x1

Chrome tube lengths may vary by model.

C x2

Parts List

Located in separate
mounting bracket pack

G x4

2

Front

Tools Included

I x1

J x1

E x8 F x4

Back

B

E x4

1

Front

Assistance is
Required

E x4

Tighten until

secure.

A

I

No less than 3˝ below
the top of the tubes.

C x2

NOTICE:
Please refer to
any optional
shelf assembly
before starting
step 2.

C

C

I

3

Back

B

D

F x4

G x4

J

Follow the instructions provided
in the mounting bracket package
to complete assembly.

Back

Front

WFST Installation Instructions

37”-63” Universal Flat Panel Display Tilted Wall Mount

11/6/13

THE WARRANTY W

ILL ONLY BE VALID IF YOU FOLLOW THE INSTRUCTIONS CAREFULLY.

Please do not begin installation until you have thoroughly read and understood these instructions.
Improper installation may cause serious injury and/or damage. It is recommended thata qualified

contractor install the WFST Universal Tilted Wall Mount.

Make sure that the wall you plan to use will safely support four times the combined weight of the

mounted equipment, including its accessories.

The WFST Universal Tilted Wall Mount supports LCD and Plasma Flat Panel Displays

from 37 to and supportsamaximum load of kg lbs

This products suits displays with 800mmx500mm(32 x20 mounting hole patterns

" "

" "

A second person will be required to assist with several st

0028.0936

( ).

eps.

.)

The manufacturer does not accept responsibility for incorrect installation.

Metal washer (x4)Ø6

Spacer (x4)

Wall Plate(x1)

Lag Bolt

8*70mm(x4)

Anchor(x4)

TOOLS REQUIRED:

Power Drill
1/4”

or 1/2” Drill Bit
Phillips Head Screw Driver
Spirit Level

Left Hook

Bracket(x1)

Right Hook

Bracket(x1)

M5x16 mm (x4 each)
M6x16 mm (x4 each)
M8x35mm (x4 each)

13mm(½”)
Hole

Wall Anchor

Lag bolt
8x70mm

IMPORTANT:
Tighten lag bolts s o that wall plate is rmly attached to wall,
but DO NOT over tighten. The lag bolts can b e damaged b y
over tightening which will strip their threading.
Final tightening oag bolts should be done b y hand using
a ratchet wrench and socket.

TIP:
Useaspirit level to
ensure the wall p late
is horizontal.

6mm(1/4”)
Hole

Lag bolt
8x70mm

TIP:
Use a spirit level to
ensure the wall plate
is horizontal.

Timber Stud

1 / 2