Luxor|H.Wilson WCFLCDM User Manual

H. Wilson Company

PO Box 290
Waukegan, IL 60079
Phone: [phone]
Fax: [phone]
www.hwilson.com
[e-mail]

Parts for WCFLCDM

(1) ceiling mounting bracket (1) two-part mounting assembly
(4) arms (4) 3" screws & washers

1

(1) 6

⁄4" threaded pipe (4) slotted L brackets

(4) L brackets, no slots (12) 6mm nuts
(12) 6mm shoulder screws (16) 6mm washers
(6) M6 hexhead screws (4) plastic spacers

WCFLCDM
Universal Fixed Height LCD
Projector Mount

Instructions:

1. Secure ceiling mount to ceiling using (4) 3" screws and
washers. Place washer on the outside of hole of mounting bracket,
then screw in the 3" screw. See Diagram A.

NOTE: Do NOT attach to a drop ceiling.

2. Attach the 6" threaded pipe by screwing into the mounted ceiling
bracket. See Diagram A.

3. Attach one part of the mounting assembly to the 6" threaded
pipe by screwing it onto pipe, making sure the larger slotted holes
are facing in the direction the projector will be facing.
See Diagram B.

3. Attach (4) arms to mounting assembly using 6mm shoulder
screws. Do not tighten. Determine correct position of arms for
projector location and then tighten the (4) nuts. See Diagram C.

4. Take one slotted L bracket and attach to top of slotted arm
bracket using (1) 6mm shoulder screw, nut and washer. Then take
unslotted L bracket and attach to outside of slotted L-bracket using
(1) 6mm carriage bolt, nut and washer. Do this to all four arms.

5. Attach this assembly to other part of mounting bracket using 6mm
shoulder screws & nuts. Do NOT tighten. Determine correct posi­tion of arms for projector location and then tighten the (4) nuts. See
Diagram E.

6. Connect projector to arms and bracket assembly using screws that
are recommended by your installer. Align arm and bracket assembly
over the female fittings on your projector. Place nut over female fit­ting on top of arm. Thread screw through the nut and into the female
fitting on the projector. When screw is in palce securely, tighten nut.
Do not over tighten. OPTIONAL: We have provided (4) spacers to
prevent marring of LCD surface; to create ventilation where neces­sary, and to allow level attachment of projector if necessary. See
Diagram B or C.

7. Take projector and bracket & arm assembly and attach to mounted
pipe assembly by using (4) M6 hexhead screws and washers. Insert
the bolt and washer on the outside of the bracket and tighten into
the welded nut on the inside of the bracket. Diagram F.

OPTIONAL: For tilting position loosen the (2) bolts in Slot A (See
Diagram B) located on side of mounting bracket. Adjust for preferred
tilt. Level or up to 10 degree tilt. Tighten bolts when tilt is correct.

Diagram A

Diagram C

Diagram E

Diagram B

Slot A

LCD Projector will face
in this direction. Note
placement of slotted
holes.

Diagram D

Diagram F

8. To secure the ceiling mounting bracket and mounting assembly,
use (2) M6 hexhead screws.

Please have a professional install this H. Wilson Product.