Page 1
Student-M (Manual Height Adjustable Student Desk)
Assembly Guide
Top with plastic
drawer attached
Left leg frame
Right leg frame
Left leg frame
Extension
Right leg frame
Extension
Upper support bar
Lower support bar
10/27/16
Lower shelf for book storage
1/6
Page 2
Wood screws to secure
the top to the frame
Set screws for leg
height adjustment
Set screw hex wrench
Counter sunk screws
QTY 16
Support bar screws
Support bar washers
QTY 4
Step 1: Gather parts B, C, G, N, P, and L. Install the support bar to the left and right leg frame
using the support bar screws and washers and the hex wrench.
QTY 4
Assistance Required
QTY 4
QTY 8
Screwdriver needed
10/27/16
2/6
Page 3
Step 2: Gather parts H, M, and L. Install the lower shelf with the counter sunk screws and the hex wrench.
Step 3: Gather parts D, E, F, N, P, L.
Step 3A: Install D, E into the base frame.
Step 3B: Install F using N, P and L
3/610/27/16
Page 4
Step 4: Gather parts H, M, and L. Place the top upside down on a protected surface.
Assistance Required
Step 5: With assistance, rotated the desk back over
Assistance Required
9/28/16
4/6
Page 5
Step 6: Determine what height you need. Note that you can always adjust
later to t your needs. Note the lowest and tallest setting 26” through 42”. There are adjustment points
at 1” increments to adjust your height. When you reach your desired height, set screws lock it in position.
Lowest Position
Tallest Position
5/610/27/16
Page 6
Step 7: Gather parts K and L. With assistance, pull the desk to the desired height,
and secure in place with the set screws and set screw hex wrench.
Assistance Required
Tighten (4)
set screw to
lock in position
Strong drawer with
additional pencil groove
Height range of 26-42
in 1” increments
Assembly is complete
Durable top with
pencil groove
Back pack hooks
Desk Features include:
Lower shelf
for book storage
Adjustable
6/610/27/16
Loading...