Page 1
Stand Alone or Extender Installation
Instructions for the RECLAIM™ Room Divider Panels
Parts:
1
Please read all instructions before installation. Start by laying the Room Divider Panel on a large, at,
stable surface. Find the pre-drilled holes in the bottom of the divider. Take the set of feet that came with
the product and slide them in until the round disk on the foot is up against the Divider Panel.
Box 1 Box 2
Room Divider Panel x1
* Please note: The foot type included in box 2 depends on SKU ordered.
Flat Feet x2
(Stand Alone)
Flat Foot x1
Peg Foot x1
(Extender)
Or
LuxorFurn.com/Reclaim
Page 2
2
Very carefully rotate Divider Panel o of at surface into a standing position on the oor. For best
results, make sure feet are at and even against the oor.
Or
LuxorFurn.com/Reclaim
Page 3
3-Panel or Multiple Set Installation
Parts:
1
Box 1 Box 2
Flat Foot x3
Peg Foot x3
Room Divider Panel x3
Start by laying the Room Divider Panels on a large, at, stable surface. Please note that the Panel with
zippers on both sides goes in the middle and the outside Panels should have the zippers facing
inwards towards the middle Panel. Find the pre-drilled holes in the bottom of the dividers and make
sure they are all on the same side of the table. Next, nd the zipper tabs and make sure they are at
the top of the Panels. Zip the Panels together by pulling the zipper tabs from the top of the panel all
the way to the bottom of the zipper.
LuxorFurn.com/Reclaim
Page 4
2
Once the Panels are zipped together, gather the sets of feet for the Panels. Slide the feet in until the
round disk on the foot is up against the Divider Panel. Please note the foot placement shown below.
The Flat feet need to go on the outside of the end Panels for optimal stability.
LuxorFurn.com/Reclaim
Page 5
2
With help, very carefully rotate Divider Panel o of at surface into a standing position on the oor.
For best results, make sure feet are at and even against the oor.
Assistance
Recommended
LuxorFurn.com/Reclaim
Loading...