LuxHome LHR100SU Instruction Manual

433MHz Wire Free

Remote Control

LHR100SU

Instruction Guide

2

LuxHome

433MHz Wire Free

Remote Control

These instructions should be read in conjunction with your System Installation
and Operating Instructions and be retained for future reference.

Introduction

The LuxHome Remote Control is designed for use with LuxHome Wire Free Intruder
Alarm systems operating on 433MHz only.

The Remote Control Unit is used to Arm and Disarm the system. The Remote will
activate the Instant Arm, Part-Arm/Delay-Arm or Disarm functions dependent upon
which System it will be used with (refer to your System Installation and Operating
Manual).

The Remote Control also incorporates a Personal Attack Switch (PAS). Activating the
PAS will immediately initiate a Full Alarm condition whether the system is Armed or
Disarmed, (unless the system is in Service, Test or Program mode).

Any number of Remote Controls can be used with your system, providing they are all
coded with the same system House Code.

The Remote Control is powered by a CR2032 type Lithium Cell battery which under
normal conditions will have a typical life up to 1 year. Under normal battery conditions
the LED on the Remote Control will only illuminate when a button is pressed. However,
under low battery conditions the LED will flash every time the button is pressed. When
this condition occurs, the battery should be replaced as soon as possible.