Lutron Electronics Serena, Serena CS-EDU-YK-BULK, Serena CS-EDU-YQ-BULK Installation Manual
Serena® Remote-Controlled Shades
Insulating Honeycomb Shades
Motorized shade with wireless radio frequency (RF) control.
Installation Guide—Please Read Before Installing
1 Prepare to Install
Important Notes
Please Read Before Installing
!
WARNING: SHOCK HAZARD. Can cause serious injury or death. Read and follow all instructions.
!
CAUTION: RISK OF FALLING OBJECTS. Securely install the shade system per the mounting instructions.
Failure to do so could result in minor or moderate injury.
1. Read, follow, and save these instructions.
2. When mounting the brackets, make sure you are screwing into wood studs if possible. If not, you must use
appropriate fasteners (not included) for the mounting surface.
3. Make sure the brackets are aligned with each other. If not, the shade may not properly snap into the brackets.
4. Install the shade on its brackets and ensure a clear path for its travel before installing batteries.
5. Keep all LTE devices (routers, mobile phones, etc.) at least 3 ft (1 m) away from shade.
English
Included Components
•
Shade
•
Mounting brackets
•
Mounting screws
•
Spacers, if applicable
Required Tools
•
Pencil
•
Tape measure
•
Drill with 3/32" drill bit
•
#2 Phillips screwdriver
Power Source Options (sold separately)
•
Batteries (type and quantity vary with shade width):
Eight (8) AA, lithium
or
Four (4) D, alkaline
Rechargeable
batteries
Six (6) D, alkaline
Eight (8) D, alkaline
CE Information
(For model numbers CS-EDU-YKBULK and CS-EDU-YQ-BULK)
Lutron Electronics hereby declares
that CS-EDU-YK-BULK and
CS-EDU-YQ-BULK are in compliance
with the essential requirements and
other relevant provisions of Directive
1999/5/EC. A copy of the DoC can
be obtained by writing to:
Lutron Electronics Co., Inc.
7200 Suter Road
Coopersburg, PA 18036 U.S.A.
TRA Compliance Information
(For model number CS-EDU-YK-BULK)
TRA
•
Individual Power Supply:
CSPS-P1-1-6-WH
•
10 Output Power Supply Panel:
CSPS-P1-10-6
Registered No: ER0096954/12
Dealer No: 0016561/08
1
Lutron Electronics Co., Inc., 7200 Suter Road, Coopersburg, PA 18036-1299, U.S.A.
Printed in the U.S.A. 8/13 P/N 368-3194 Rev. B
Serena® Remote-Controlled Shades
Insulating Honeycomb Shades
Motorized shade with wireless radio frequency (RF) control.
Installation Guide—Please Read Before Installing
2 Mount Shade
2.1 Verify Correct Shade Size
Hold the shade up to the window to make sure it is the correct size.
NOTE: For outside mounting, center the shade with the window and mark the wall
or trim at each end of the shade.
English
2.2 Attach Brackets to Mounting Surface
•
Use Bracket Placement Table found on next page to position bracket
on mounting surface and mark hole locations for pre-drilling.
•
Use a level to make sure the marks are aligned.
•
Pre-drill holes for the screws. Repeat for all brackets.
•
Install the mounting brackets using the provided screws or other appropriate fasteners.
Inside Mount Outside Mount
window frame
bracket
1.25 in (32 mm)
window glass
minimum
On Trim
angled spacer*
bracket
window
trim
* If window trim is angled,
place an angled spacer
(not included) behind each
bracket. Ensure that the
trim is level before placing
the bracket flush against
its edge Pre-drill a hole
through the spacer.
wall
Outside Mount
Above Trim*
* Hole locations
should be no less
than 2.75 in (70 mm)
above the trim.
spacer
bracket
window
trim
(70 mm)
minimum
wall
2.75 in
2
Lutron Electronics Co., Inc., 7200 Suter Road, Coopersburg, PA 18036-1299, U.S.A.
Printed in the U.S.A. 8/13 P/N 368-3194 Rev. B
www.lutron.com/honeycombmaintenance
www.lutron.com/honeycombmaintenance
Serena® Remote-Controlled Shades
Insulating Honeycomb Shades
Motorized shade with wireless radio frequency (RF) control.
Installation Guide—Please Read Before Installing
English
Bracket Placement
Shade width 14.5 in – 25.875 in (368 mm – 657 mm)
1 1 1
2
Top view of shade
4 4
Front view of shade
3
Shade width 26 in – 45 in (660 mm – 1143 mm)
1
2
Top view of shade
2 in
(5 cm)
2
1
2
3
2 in
(5 cm)
2
Top view of shade and bracket
1. Bracket
2. Cord lift spool
3. Drive
4. Yellow bracket label
Shade width 45.125 in – 72 in (1146 mm – 1829 mm)
2 in
(5 cm)
1
2
Top view of shade
2
1 1
3
2 in
(5 cm)
Shade width 72.125 in – 96 in (1832 mm – 2438 mm)
1 1 1 1
Top view of shade
2 in
(5 cm)
2
2 2 2
2
2 in
(5 cm)
3
2 in
(5 cm)
1/3 w 1/3 w1/3 w
3
Lutron Electronics Co., Inc., 7200 Suter Road, Coopersburg, PA 18036-1299, U.S.A.
Printed in the U.S.A. 8/13 P/N 368-3194 Rev. B
Loading...