Lumme LU-2102 Instruction Manual

MEAT GRINDER

Instruction manual

МЯСОРУБКА

Руководство по эксплуатации

LU-2102

DESCRIPTION

1. On / Off switch

2. Reverse switch

3. Locking knob

4. Body

5. Opening

6. Food pusher

7. Food tray

8. Mincing tube

9. Spiral drive

10. Cutting blade

11. Kebbe attachment A

12. Kebbe attachment B

13. Cutting grille (fine)

14. Cutting grille (coarse)

15. Cutting grille (medium)

16. Fixing ring

2

IMPORTANT SAFETY INSTRUCTIONS

• Please read this instruction manual carefully before use and keep in a safe place for future reference.

• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless

they have been given supervision or instruction concerning use of appliance by a person responsible for their safety. Children should be supervised to ensure that they do
not play with the appliance.

• Before the first connecting of the appliance check that voltage indicated on the rating label corresponds to the mains voltage in your home.

• Home use only. Do not use for industrial purposes.

• Do not use the meat grinder for any other purposes than those described in this instruction manual.

• Do not disassemble the appliance when it is plugged to the power supply. Always unplug the meat grinder from the power supply when not in use and before cleaning.

• To protect against the risk of electric shock, do not immerse the appliance in water or in any other liquids.

• Keep away from children.

• Do not leave the meat grinder switched on when you do not use it.

• Do not use other attachments than those supplied.

• Do not overload the appliance.

• Keep the cord away from sharp edges and hot surfaces.

• Do not place the appliance near gas or electric oven or store at heated surface.

• The blades are very sharp, so handle them with care.

• Do not push products into the appliance by fingers while it is in use.

• If food becomes lodged in feeding tube, use pusher to push it down. If this doesn’t work, turn the motor off, unplug the appliance and disassemble it to remove remaining

food.

• Do not carry the unit by the food tray or feeding tube. Be sure to hold the housing with both hands.

• Do not fix the cutting blade and cutting grill while using kebbe maker.

• Do not operate after malfunction or damage of cord.

• Do not grind hard food, such as bones, nuts, ginger or other products with hard fiber.

• Do not operate for more than 15 minutes at one time. Turn off switch and let it rest for at least 10 minutes to cool down the motor, otherwise the motor may be

damaged.

• Do not attempt to repair, adjust or replace parts in the meat grinder. Repair the malfunctioning appliance in the nearest service center.

INSTRUCTION FOR USE

• Wash all parts (except body) in warm soapy water.

3

• Before plugging in, ensure the appliance is switched off.

• Do not immerse motor unit into water.

ASSEMBLING

1. Place the mincing tube onto the opening of the motor housing. Holding the mincing tube with one hand place the locking knob into the hole on the side of the
motor housing and tighten it clockwise.

2. Place the feed screw into the mincing tube, long end first, by turning the feed screw slightly until it is set into the motor housing.

3. Place the cutting blade onto the feed screw shaft with the blade facing the front as illustrated. If it is not fitted properly meat will not be ground.

4. Place the desired cutting plate next to the cutting blade, fitting protrusions in the slots.

4