Blood Pressure
Monitor
Instruction
Manual
2
Model Number 1092
ID #06/00
Requires 2 “AAA” Alkaline Batteries
YEAR
LIMITED W
ARRANTY
TABLE OF CONTENTS
Identification of Parts
Battery Installation/Replacement
Attaching the Wrist Cuff and Posture During . . . . . . . . . . . . . . . 4
Measurement
Measurement . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
Subsequent Measurement . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
Automatic Power-off Function
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
. . . . . . . . . . . . . . . . . . . . . . . . 4
. . . . . . . . . . . . . . . . . . . . . . . . . . 6
Memory Recall . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
Memory Clear Function . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
Description of Display Marks . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9
Warranty . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . 10
Identification of Parts
ts
3
4
Battery
Installation/Replacement
•
To use the unit, you must install
batteries.
• Open battery cover as illustrated.
Install or replace two new batteries, making
sure the polarities (+ and -) on the battery
match the polarities on the case.
• Replace battery cover.
• If the Low Battery indicator “ “ appears on
the display, both batteries must be replaced.
• “AAA” alkaline batteries or equivalent are suitable for this blood pressure meter.
Attaching the Wrist Cuff
and Posture During
Measurement
• The blood pressure is measured at the wrist.
Therefore, rolling up the sleeve is no longer
necessary.
• Wrap the wrist cuf
f around your left wrist with
the display panel on the inside of the wrist.
• Pull the wrist cuff to fit wrist size and fasten
velcro.
Wrist circumference: 5.4-7.8 in.
Rest left elbow on a table so that the cuff is at
heart level. Relax the lower arm across the table
and remain still.
Perform measurements in either a seated or
reclining posture with the left palm turned
upward.
1/2 inch
Measurement
NOTE: Unit measures on inflation.
• To start the measurement
Press the “Power/Start” switch.
• The heart symbol will flash and the buzzer will
sound for 1 second. When the unit completes the
preparations for measurement, the buzzer will
sound three more times.
If batteries are weak, “❤ ” mark will not appear.
• Pr
essurization and measuring begin.
• When a pulse is detected, the pressure value
moves to the lower side of the display
. At this time
the “❤” mark flashes and buzzer beeps.
• Once the blood-pressure measurement has stabi-
lized, pressurization is discontinued and the air in
the cuff is automatically let out.
• The buzzer sounds for about 2 seconds, and the
high and low blood pressure are r
espectively dis
-
5
played one above the other.
• Unless an error is generated, the measurement
results are automatically stored in memory (Up to 7
sets of results can be stored ). When there are
already 7 sets of results in memory, the oldest one is
automatically erased and overwritten with the newest.
• Blood pressure values and pulse rate are alternately displayed.
The unit will continue to display the measurement until
power is turned off.
• Turn Power off
Press the “Power/Start” switch to turn off.
NOTE:
To discontinue a measurement for any reason, press the
“Power/Start” switch. This causes the “wrist cuff” to rapidly
deflate.
Automatic Power OFF Function
If the unit is left on after measurement, an “Automatic PowerOFF Function” turns the power off after approximately 3 minutes.
To continue with another measurement press the “Power/Start”
switch to turn the unit on.
6
Subsequent Measurement
When a measurement needs to be made again, the time
between 2 measur
ements must be at least 10 minutes.
Memory Recall
• You can r
ecall stored data by pressing the
“Memory Recall” switch at any time, EXCEPT while
taking a measurement.
• Up to 7 sets of measurement results can be stored
in memory. Memory cell No. 1 is always used to
store the newest set of results.
• When pressing the “Memory Recall” switch, the
memory cell number is displayed. The stor
ed
measurement results (systolic/diastolic blood pressure) are then displayed.
• If the “Memory Recall” switch is pr
essed again, the
prior measurements are displayed in the order they
were taken.
Memory Clear Function
While the memory data to be cleared is indicated
and the “Memory recall” switch is pressed for 3
seconds, the buzzer will beep and the memory
data is clear
ed.
7
8
Description of Display Marks
Pulse could not be
measured.
Repeat the measurement without moving
the arm.
DISPLAY MARK CONDITION/CAUSE
CORRECTIVE ACTION
Pulse could not be
measured accurately.
The cuff was inflated to
more than 280 mmHg.
Pressurization is not possible. The wrist cuff was
not wrapped properly.
Exhaust the air from
the cuff.
The arm moved during
measurement.
Batteries are weak.
There is a problem with
the device.
There is a problem with
the unit.
After rewrapping the
cuff, repeat measurement.
After rewrapping the cuff,
conduct the measurement
without moving.
Repeat the measurement without moving
the arm.
Replace the batteries.
Return to Lumiscope
service Department.
Return to Lumiscope
Service Department.
9
Switch
Inflation
Exhaust
Rated Voltage
Power Source
Power Consumption
Battery Life
Automatic Power-Off
Memory Function
Dimension
Weight
LCD
LCD
Indication
Accuracy
Operating
Environment
Storage
Environment
Temperatur
e
Humidity
T
emperature
Humidity
Measurement
Range
Measuring Principle
Measurement Localization
Cuff
Wrist Circumference Range
Model No.
1092
View Size
Digit Size
Marks
Systolic blood pressure: 3 digits
Diastolic blood pressure:
3 digits
Pulse rate: 3 digits
Measuring ❤
Battery
1.44(H) x .904(W)in (36(H) x 22.6(W)mm)
.44(H) x .22(W)in (11(H) x 5.5(W)mm)
Power/Start switch, Memory recall switch
Automatic Inflation by Internal Pump
Electromagnetic Valve
3 VDC
2 “AAA” Size Batteries
1.0W
Approx. 400 times (180mmHg, 1time/day, 22°C)
Approx. 3 min.
Seven Memories Function
2.8(H) x 2.68(W) x 1.16(T)in (70(H) x 67(W) x 29(T)mm)
Approx. 3.5 oz. (100g)
50 to 104°F (10 to 40°C)
30 to 85%RH
-4 to 140°F (-20 to 60°C)
10 to 95%RH
Pressure
Pulse
Pressure
Pulse
Pressure
Pulse Rate
Oscillometric Method
Left Wrist
Soft Cuff
5.4 to 7.8 in. (13.5 to 19.5cm)
0 to 280 mmHg
40 to 180 Pulses/min.
±3 mmHg
±5% of r
eading
Alternatively
Specifications
CAUTION:
1. Measurement of blood pressure may not be possible for someone with a weak pulse or cardiac
arrhythmia.
2. This product is not intended to be used in the diagnosis or treatment of disease.
3. If you have high blood pressure and/or other cardiovascular conditions or diseases, this device
should be used in consultation with your doctor
.
4. Consult your doctor if you have questions about your blood pressure or pulse.
5. Specifications are subject to change without notice due to impr
ovements in performance.
Loading...