Lumineux 430373 Installation Instructions

4CCT Gimbal FRD Downlight

FF

A

G

INSTALLATION INSTRUCTIONS

IP65

4CCT

5 YR

Warranty

Flicker

Free

60º

30, 60, 90 mins

7W

Dimmable

Avon PRO Gimbal

READ THESE INSTRUCTIONS

THOROUGHLY BEFORE

INSTALLATION KEEP THESE

INSTRUCTIONS FOR

FUTURE REFERENCE.

IMPORTANT:

This product must be installed

by a qualifi ed electrician or

competent person, and in

accordance with current building

and IET wiring regulations.

BOX CONTENTS

This lighting  xture has been properly
packed to avoid damage during
transit. Before commencing with the
installation carefully inspect the
luminaire to con rm there is no
damage. DO NOT INSTALL if any
damage has occurred to the  xture
or any of its components:

• Light Fitting

• Instruction Manual

• Quick Connector

TOOLS REQUIRED

1

2

on

off

70mm

Hole

Cut-Out

4 5

4CCT switch

3

Earth terminal for

continuity only

PLEASE NOTE:
Ensure cable strip length
is 15mm for strong connection.

6

Electrical wiring

connections

NEUTRAL (N)

Blue

EARTH

Green/Yellow

LIVE (L)

Brown

15mm

Downlight

PLEASE READ THESE INSTRUCTIONS

BEFORE INSTALLATION.

WARNING: Risk of electric shock! Isolate
the mains power before proceeding.

• Turn off the mains power before performing
inspections, installation, or removal

• Verify that the supply voltage is correct by
comparing it with the luminaire label information

• It is the installers responsibility to ensure installation
is suitable for the total load of the luminaire(s). The
supply cable, fuses/circuit brakers must be correctly
rated for the electrical load and considering for any
transient inrush currents that may occur

• Do not perform insulation strength or resistance
tests on installed luminarie(s) connected

1. Isolate the circuit.

2. Drill 70mm hole cut out.

3. Strip cable sleeves to reveal 15mm wire.

Push wires into connector and push clamps
downwards to secure the wires.

4. Attach connector to other half on light  tting.

• Hole Saw
drill 70mm

• Cable

5. Select CCT option by moving switch on

Twist bezel to reveal

4CCT switch.

on

connector to desired setting.

6. Grip spring clamps and move vertically.
Insert downlight into pre-drilled hole and
clamps will spring back and secure light

2700K

3000K

4000K

6000K

Manby Business Park, Manby, Lincolnshire, LN11 8UT
Lumineux is a B&T Associates Ltd company.

Technical Helpline: [phone]

off

 tting. Repeat for any other downlights,
then connect power on.

www.lumineux.co.uk

DISPOSAL

The light source of this unit is not
replaceable; when the light source
reaches its end of life the whole
luminaire shall be replaced.

Disassemble instructions for end of
life disposal available on website.

Disposal of Electronic Equipment
WEEE Directive 2002/96/EC This
product falls within the scope of
the Waste Electrical & Electronic
Equipment Directive (WEEE), which
means the product should not be
disposed of as normal household
waste. Please recycle where
facilities exist or check with your
Local Authority. RoHS – All
components and materials used in
this product are RoHS 2002/95/EC
compliant.

Specications may change from time
to time. The information contained
in this leaet is for guidance only
and should not be considered as
always accurate and should be
treated as not representative.

Avon PRO 4CCT Gimbal Fire Rated Downlight

AVON GIMBAL DOWNLIGHT DIMENSIONS

Part No. Description Watts L (mm) W (mm) H (mm) Weight

430373

430373-MP

Installation Engineers Contact Details: Luminaire Reference / Location Date

Name:

Avon 4CCT Gimbal

Downlight

Avon 4CCT Gimbal

Downlight Multipack

7W 87 65 38 0.2Kg

7W 87 65 38 0.2Kg

Tel:

W (mm)

L (mm)

Dimming

To achieve good dimming results, use dimmers that have been
approved for electronic LED drivers. i.e:

• Varilight V-Pro-JDLP401S

H (mm)

• Zano ZGRIDLED150

• Hamilton VWP1XI_EDITB100

• Schneider GGBL6012LMS

If in doubt - contact the dimmer manufacturer for advice.

WARRANTY

This luminaire is warranted for a
period of 5 years from the date of
purchase**. The warranty could be

invalidated should the light tting
not be installed according to these
instructions, outside the scope of
the specication or the product
has been altered or tampered with
in any way. Please see website for
terms and conditions.

PRODUCT TEMP SPECIFICATION

Standard -10º to +40ºC

Revision 2 - AUGUST 2022

** Please see our website for more detailed information on warranty.

This product contains a light source of energy efciency Class F.

Technical Helpline: [phone]