Page 1
VC-WM14 Installation Guide
www.MyLumens.com
1. Package Contents
VC-WM14
PTZ Camera
Locking screw
*4 pcs
Installation
guide
Box Camera
Locking screw
2. Product size and hole sites
218.2 m m
17.6 mm
j
Drilling paper
M6*10 screw
x4pcs
Support arm
196.6 m m
x2pcs
j
3. Precautions for installation
3.1 Load Capacity: 2 Kg
3.2 Follow these procedures step by step, to ensure correct installation of the
device.
3.3 Do not install the bracket on an unstable ceiling or wall. Install the bracket in
a position that does not cause an obstruction or hazard.
3.4 Do not use the VC-WM14 to mount box cameras to a wall or ceiling. Using
VC-WM14, box cameras should only be mounted to a monitor.
3.5 For detailed dimensions and a technical drawing, please go to the
Lumens website > Service Support > Download
Area.
https://www.MyLumens.com/Support
4. Instruction for installation steps
4.1 Instruction for ceiling installation
1. Use the Drilling Paper to mark and drill holes in the ceiling.
2. Fix the short side of the metal bracket to the ceiling.
3. Fix the camera on the long side of the metal bracket and lock with 4x screws.
4. Loosen the hexagonal screws on both sides to adjust the installation angle.
Tighten the screws to fix the position.
k kk
j
j Foot pad hole
k Screw hole
l Screw hole for box Cameras
5100453-51 MAR. 2022
l
j
Copyright © Lumens Digital Optics Inc. All rights reserved.
Page 2
www.MyLumens.com
4.2 Wall Installation
1. Use the Drilling Paper to mark and drill holes in the wall.
2. Use accessory connecting support arm (x2pcs) and locking screw (x4pcs)
3. Fix the short side of the metal bracket to the wall.
4. Fix the camera on the long side of the metal bracket and lock with 4x screws.
5. After finishing, confirm that the connecting support arm and the hexagon
socket screws on both sides are locked and fixed.
4.3 Mount to a Display
1. Install the camera on the short side of the metal bracket, and attach the
camera with the appropriate screws.
> Camera: Screws x4PTZ
> Box Camera: Screws x1
2. Place on top of the display.
3. Adjust the angle of the bracket to grip the top and rear of the monitor.
4. Fasten the hexagonal socket screws on both sides to secure the mount.
Copyright © Lumens Digital Optics Inc. All rights reserved.
Loading...