Lumens is a trademark that is currently being registered by Lumens Digital Optics
Inc.
Copying, reproducing or transmitting this file is not allowed if a license is not
provided by Lumens Digital Optics Inc. unless copying this file is for the purpose
of backup after purchasing this product.
In order to keep improving the product, Lumens Digital Optics Inc. hereby
reserves the right to make changes to product specifications without prior notice.
The information in this file is subject to change without prior notice.
To fully explain or describe how this product should be used, this manual may
refer to names of other products or companies without any intention of
infringement.
Disclaimer of warranties: Lumens Digital Optics Inc. is neither responsibl e for any
possible technological, editorial errors or omissions, nor responsible for any
incidental or related damages arising from providing this file, using, or operating
this product.
English - 2
Chapter 1 Safety Instructions
Please use the product following the safety instructions below:
1. Operation
1.1 Please use the product in the recommended operating environment.
1.2 Do not place Light Engine in tilted position.
1.3 Do not place the product on an unstable trolley, stand or table.
1.4 Do not use this produc t near water or source of heat.
1.5 Use attachments only as recommended.
1.6 Use the type of power source indicated on this Product. If you are not
sure of the type of power available, consult your dealer or local electricity
company for advice.
1.7 Always take the following precautions when handling the plug. Failure to
do so may resu lt in sparks or fire.
Ensure the plug is free of dust before insert ing it into a socket.
Ensure that the plug is inserted into the socket se curely.
1.8 Do not overload w all s oc kets, extension cords or multi-way plug boards to
avoid potential risks.
1.9 Do not block slots and openings in the case of this product as poor
ventilation may lead to overheating of this product.
1.10 Except as specifically instructed in this User Manual, do not attempt to
open or remove covers by yourself. It may expose you to electric s hoc k o r
other hazards. Refer a ll serv icing to licensed ser v ice personnel.
1.11 Unplug the HD Camera from the wall outlet and refer servicing to licensed
service personnel when the following situations happen:
If the power cord or plug becomes damaged or frayed.
If liquid is spilled into the Product or the Product has been exposed to
rain or water.
2 Installation
2.1 Do not install this product in the embedded way u n less there is proper
ventilation device.
3 Battery
3.1 The batteries for this product is not removable, in case of failure, please
consult with the original factory for maintenance.
3.2 Do not use the product a ny mor e when t he indic ator fl ickers red indicating
low power, otherwise the capacity of storage of the battery would be
affected.
English - 3
3.3 The charging of the product may cause overheating, do not place the
product in the place where it is badly ventilated.
4 Storage
4.1 Do not place the Product where the cor d can be stepped on as this may
result in fraying or damage to the lead or the plug.
4.2 Never push objects of any kind through cabinet slots. Never allow liquid of
any kind to spill into the Product.
4.3 Unplug this product during thunderstorms or if it is not going to be used
for an extended period.
4.4 Do not place this prod uct or accessories on top of vibrating equipment or
heated objects.
5 Cleaning
5.1 Unplug all the cables before cleaning. Use a damp cloth for cleaning. Do
not use liquid or aerosol cleaner s .
Precautions
Warning 1: To reduce the risk of fire or electric shock, do not expose this
appliance to rain or moisture.
Note
Risk of Electric S hock
Caution: To reduce t he r isk of electric shock, do not remove cover (or back). No
user-serviceable parts inside. Refer servicing to licensed service personnel.
This symbol indicates
that this equipment may
contain dangerous
voltage which could
cause electric shock.
Please do not open it by yourself.
This symbol indicates that
there are important
operating and
maintenance instructions
in this User Manual with
this unit.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
English - 4
cause harmful interf er ence to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separ ation between the equipment and receiver.
—Connect the equipment i nto an ou tle t on a circuit dif ferent from that to which the
receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement
This device complies with FCC ra diat ion exposure limits set forth for an
uncontrolled environment and it also complies with Part 15 of the FCC RF Rules.
This equipment must be installed and operated in accordance wi th pr ov id ed
instructions and the antenna(s) used for this transmitter must be installed to
provide a separation distance of at least 20 cm from all persons and must not be
co-located or operating in conjunction with any other antenna or transmitter.
End-users and installers must be provide with antenna installation instructions
and consider removing the no-collocation statement.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
Caution
Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
EN55022 (CE Radiation) Warning
This product is intended for use in a commercial, industrial, or educational
environment. It is not intended for residential use.
This is a Class A product. In a residential environment it may cause radio
interference, in which case the user may be required to take adequate measures.
The typical use is in a conference room, recept ion room or hall.
English - 5
Chapter 2 Package Content s
DC-W50
Adapter
Quick Start Guide USB connector holder
(For download of other
language versions, please
visit Lumens website)
Power Cord
Appearance may vary
depending on
country/region
English - 6
Chapter 3 Product Overview
3.1 DC-W50
7. LED Indicator
6. LAN
5. USB connector
fixing hole
4. USB Port
3.Default Values
1.
Power Switch
2.WPS Button
8.HDMI Output
English - 7
3.2 Lock USB Connector Holder
3
1
2
1. Disconnect the ball chain on the USB connector holder.
2. Thread the ball chain through the connector fixing hole on DC-W50.
3. Shackle the ball chain.
English - 8
Loading...
+ 20 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.