Luma Comfort EC220W Installation Manual

7

Say Goodbye to Ugly Products

OPERATING INSTRUCTIONS

BEFORE USING YOUR EVAPORATIVE COOLER

The Luma Comfort EC220W works as an evaporative cooler, humidifier, and
air purifier in one unit. To achieve he best cooling effect from your cooler,
please follow these suggestions:

• Unlike air conditioners, evaporative coolers work best in areas with a fresh

air supply. If using the unit indoors, place it near an open window or leave
the door to the room open. You can also open another window or door on
the opposite side of the room to create a “flow through” cooling effect.

• Turn on your evaporative cooler before the ambient temperature reaches

excessively high levels. Due to the low operating costs of the unit, it is very
cost effective to leave the cooler running for extended periods.

• Add cold water to the tank. Ice can also be added for an enhanced cooling

effect. After adjusting the COOLER dial, the unit’s high-efficiency cooling
pads will become damp. Air is then drawn through the rear panel and over
the pads to release cool, clean air. Please note that it may take a few
minutes for the cooling pads to become fully saturated with water.

• If the humidity levels in your environment increase, the EC220W can also

be used as a fan to circulate the air. Simply turn on the unit but do not
adjust the COOLER dial.

8

www.LumaComfort.com

SET UP AND OPERATION

Carefully remove all packaging materials and retain for future storage/use.
Make sure there is no residual foam left in any of the components. No tools will
be required to assemble this evaporative cooler.

1. Choose a suitable location for your evaporative cooler. This product works

best in areas with a fresh air supply.

2. Fill the water tank with clean water through the water inlet. Ice cubes may

also be used for added cooling. Ensure that the casters are locked with the
lever fully up. This is so the casters can support the weight of the unit.

3. Connect the unit to a power supply and turn the SPEED dial. The fan will

start.

4. To begin cooling, turn the COOLER dial to the ON position. To experience

the full cooling effect, wait a few minutes for the cooling pads to become
fully saturated with water.

5. Periodically check the water level on the water level indicator. If the water

tank is running low on water, turn the COOLER dial to the OFF position
and add more water/ice.

6. To turn the unit off, turn the COOLER dial to the OFF position and the

SPEED dial to the OFF position. If the unit will not be used for an extended
period of time, empty the water tank by unplugging the drain plug located
on the back of the evaporative cooler.

REFILLING THE WATER TANK

The water tank can be refilled by using one of
these methods:

• Manual: Fill the water tank by pouring water

into the tank from the back of the cooler
through the water inlet.

• Continuous: The tank can be filled

continuously by connecting a garden hose to
the continuous water supply inlet/hose
connector.