LumeLEX 2030/2031 SERIES INSTALLATION INSTRUCTIONS
Important
Warning
Product
Overview
Purpose of
This Sheet
THIS SHEET CONTAINS IMPORTANT SAFETY INSTRUCTIONS.
SAVE THESE INSTRUCTIONS.
This product must be installed in accordance with National Electrical Codes and all other
local codes by a person familiar with the construction and operation of the product and
the hazards involved.
To prevent electrical shock, turn off the power during installation or maintenance.
To reduce the risk of fire, keep away from combustible materials.
The LumeLEX 2030/2031 Series is a clean,
elegant stem mounted LED spotlight with a
discreetly hidden driver, making it appear no
different than a traditional halogen source.
With independent ratings of 97CRI, the
LumeLEX 2030/2031 series, based on the
latest in Remote Corrected Cold Phosphor
Technology by Xicato, has the highest Color
Rendering Index of any LED on the market
today, producing the most consistent, highest
quality white light and maintaining extremely
tight color control (within 2 MacAdam ellipses,
vs. the NEMA standard of 7). The LumeLEX
2030/2031 series also features a snap-out
cross baffle and accessory cartridge which
accepts up to two optical accessories, size
‘AAA’.
See the fixture label for voltage and wattage
input.
Please consult our Product Catalog or web
site for available accessories.
We recommend that you first install the
reflector and any accessories before
installing the fixture.
The purpose of this sheet is to provide step-by-step instructions to help you:
Install the fixture with any of the following: -00E fitting on an LSI track, -BUSE fitting on an LSI
Busway, -5AE canopy.
Install accessory filters and reflectors
Aim the self-locking and wrench-locking fixture
Clean the optical surfaces and reflector
LumeLEX 2030 Series Spotlight
www.LightingServicesInc.com Page 1 of 6 IS-0139_A
Changing
or
Installing
the
Reflector
Before Changing Reflector: To maintain the
fixture’s current orientation, change the reflector
with the fixture in its location. If the orientation
does change, refer to the “Aiming the Fixture”
section of this sheet. Refer to our Product Catalog
or web site for reflector options.
Follow steps 1, 2, 4, and 5 if you are installing
the reflector for the first time.
STEP ACTION
1 Turn off all power to the fixture,
including the fixture switch on the
fitting, and let the LED cool.
WARNING: LED and fixture may be
hot.
2 Remove the cylinder housing by
grasping the fitting stem in one hand
and the cylinder housing in the other.
Pull in opposite directions while
rocking the housing gently side to
side. (Fig. 1).
3 Remove the reflector by turning it
counter-clockwise, then pulling it out
of the fixture. (Fig. 2).
4 Insert the new reflector by lining up
the three tabs with the notches in the
LED Adapter Ring, and rotating
clockwise until it is secured in
place.(Fig 3)
Figure 1. Cylinder housing loosened and
notches aligned (arrow). Pull off to expose
lamp, or push onto stem to close and secure
housing.
Figure 2. Rotate reflector counter-clockwise to
remove it.
5 Close the fixture front by replacing the
cylinder housing. Align the stem
notch to the cylinder housing notch
and push the cylinder housing onto
the stem notch until it clicks into place
and is secured. (Fig. 1).
6 Restore power.
WARNING: Do not look directly at
the lit LED.
www.LightingServicesInc.com Page 2 of 6 IS-0139_A
Figure 3. The three notches in the LED Adapter
Ring. Align the reflector tabs with these
notches and rotate clockwise to secure in it.
Loading...