LPS 5528 User Manual

SAFETY DATA SHEET

www.lpslabs.com

1. Identification

LPS® BFXProduct identifier

Other means of identification

Part Number

Recommended use

Recommended restrictions

Manufacturer/Importer/Supplier/Distributor information
Manufacturer

Manufacturer

Company name

Address

Country

In Case of Emergency

Website

E-mail

05528, 05501, 05505, 05555
Not available.
None known.

ITW Pro Brands
4647 Hugh Howell Rd.
Tucker, GA 30084
(U.S.A.)
Tel: [phone]
1-800-424-9300 (inside U.S.)
+001 703-527-3887 (outside U.S.)

[e-mail]

2. Hazard(s) identification

Physical hazards

Health hazards

Environmental hazards

OSHA defined hazards

Label elements

Hazard symbol

Signal word

Hazard statement

Precautionary statement

Prevention

Response

Storage

Disposal

Hazard(s) not otherwise
classified (HNOC)

Supplemental information

Not classified.

Not classified.

Not classified.

None.

Warning

Causes eye irritation.

Wash thoroughly after handling.

IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present
and easy to do. Continue rinsing. If eye irritation persists: Get medical advice/attention.

Store away from incompatible materials.

Dispose of contents/container in accordance with local/regional/national/international regulations.

None known.

Not applicable.

3. Composition/information on ingredients

Mixtures

Alcohols, C10-16,ethoxylated

Category 2BSerious eye damage/eye irritation

CAS number %Common name and synonymsChemical name

68002-97-1

1 - 10

4. First-aid measures

Inhalation

Skin contact

Material name: LPS® BFX
05528, 05501, 05505, 05555 Version #: 03 Revision date: 10-20-2015 Issue date: 06-17-2014

If inhaled, remove to fresh air. If breathing is difficult, give oxygen. If symptoms persist, get medical
attention.

Wash off immediately with plenty of water. Get medical attention if irritation develops and persists.

SDS US

1 / 7

Eye contact

where possible). In case of shortness of breath, give oxygen. Keep victim under observation.

with water spray and remove container, if no risk is involved.

US. OSHA Table Z-1 Limits for Air Contaminants (29 CFR 1910.1000)

US. ACGIH Threshold Limit Values

Ingestion

Most important
symptoms/effects, acute and
delayed

Indication of immediate
medical attention and special
treatment needed

General information

5. Fire-fighting measures

Suitable extinguishing media

Unsuitable extinguishing
media

Specific hazards arising from
the chemical

Special protective equipment
and precautions for firefighters

Fire fighting
equipment/instructions

Immediately flush eyes with plenty of water for at least 15 minutes. Remove contact lenses, if
present and easy to do. Get medical attention if irritation develops and persists.

Call a physician or poison control center immediately. Only induce vomiting at the instruction of
medical personnel. Never give anything by mouth to an unconscious person.

Irritant effects. Symptoms may include stinging, tearing, redness, swelling, and blurred vision.
Defatting of the skin. Rash.

Provide general supportive measures and treat symptomatically.

In the case of accident or if you feel unwell, seek medical advice immediately (show the label

Water fog. Foam. Dry chemical powder. Carbon dioxide (CO2).
None known.

During fire, gases hazardous to health may be formed.

Self-contained breathing apparatus and full protective clothing must be worn in case of fire.

Firefighters must use standard protective equipment including flame retardant coat, helmet with
face shield, gloves, rubber boots, and in enclosed spaces, SCBA. Cool containers exposed to heat

General fire hazards

No unusual fire or explosion hazards noted.

6. Accidental release measures

Personal precautions,
protective equipment and
emergency procedures

Methods and materials for
containment and cleaning up

Environmental precautions

Keep unnecessary personnel away. Use personal protection recommended in Section 8 of the
SDS.

Stop the flow of material, if this is without risk. Following product recovery, flush area with water.
For waste disposal, see section 13 of the SDS.

Avoid discharge into drains, water courses or onto the ground.

7. Handling and storage

Precautions for safe handling

Conditions for safe storage,
including any incompatibilities

Do not handle, store or open near an open flame, sources of heat or sources of ignition. Protect
material from direct sunlight. Do not breathe dust/fume/gas/mist/vapors/spray. Do not get this
material in contact with eyes. Do not get this material in contact with skin. Avoid prolonged
exposure. Do not get this material on clothing. Do not use in areas without adequate ventilation.
Wear personal protective equipment. Observe good industrial hygiene practices. W ash thoroughly
after handling. Use care in handling/storage.

Keep tightly closed in a dry, cool and well-ventilated place. Keep out of the reach of children. Use
care in handling/storage.

8. Exposure controls/personal protection

Occupational exposure limits

PEL 2 mg/m3Camphor USP (CAS

76-22-2)

PEL 2 mg/m3Sodium Hydroxide (CAS

1310-73-2)

ValueComponents Type

STEL 3 ppmCamphor USP (CAS

76-22-2)

TWA 2 ppm
Ceiling 2 mg/m3Sodium Hydroxide (CAS

1310-73-2)

Material name: LPS® BFX
05528, 05501, 05505, 05555 Version #: 03 Revision date: 10-20-2015 Issue date: 06-17-2014

ValueComponents Type

SDS US

2 / 7

US. ACGIH Threshold Limit Values

TWA 5 mg/m3Triethanolamine (CAS

US. NIOSH: Pocket Guide to Chemical Hazards

102-71-6)

TWA 2 mg/m3Camphor USP (CAS

76-22-2)

Ceiling 2 mg/m3Sodium Hydroxide (CAS

1310-73-2)

Biological limit values

Appropriate engineering
controls

No biological exposure limits noted for the ingredient(s).
Good general ventilation (typically 10 air changes per hour) should be used. Ventilation rates

should be matched to conditions. If applicable, use process enclosures, local exhaust ventilation,
or other engineering controls to maintain airborne levels below recommended exposure limits. If
exposure limits have not been established, maintain airborne levels to an acceptable level.

Individual protection measures, such as personal protective equipment

Eye/face protection

If contact is likely, safety glasses with side shields are recommended. Eye wash fountain is
recommended.

Skin protection

Hand protection

For prolonged or repeated skin contact use suitable protective gloves. Chemical resistant gloves
are recommended.

Other

Avoid contact with the skin. Avoid contact with clothing. Normal work clothing (long sleeved shirts
and long pants) is recommended. Chemical resistant gloves.

Respiratory protection

Thermal hazards

General hygiene
considerations

No personal respiratory protective equipment normally required.
None known.
Always observe good personal hygiene measures, such as washing after handling the material

and before eating, drinking, and/or smoking. Routinely wash work clothing and protective
equipment to remove contaminants.

ValueComponents Type

ValueComponents Type

9. Physical and chemical properties

Appearance

Physical state

Form

Color

Odor

Odor threshold

pH

Melting point/freezing point

Initial boiling point and boiling
range

Flash point

Evaporation rate

Flammability (solid, gas)

Upper/lower flammability or explosive limits

Flammability limit - lower
(%)

Flammability limit - upper
(%)

Explosive limit - lower (%)

Explosive limit - upper (%)

Vapor pressure

Vapor density

Relative density

Liquid.
Liquid.
Colourless to light yellow.
Sassafras

Not available.

11.8

Not available.

212 °F (100 °C)

None

1 BuAc

Not available.

Not Available

Not Available

Not available.

Not available.

17.5 mm Hg @ 20°C

> 1

Not available.

Material name: LPS® BFX
05528, 05501, 05505, 05555 Version #: 03 Revision date: 10-20-2015 Issue date: 06-17-2014

SDS US

3 / 7