Lowrance electronic 000-0106-72, 000-10029-001 User Manual

Manual

Network Expansion Port 2
NEP-2

English

www.lowrance.com

www.simrad-yachting.com

Brands by Navico - Leader in Marine Elec tronics

Disclaimer

As Navico is continuously improving this product, we
retain the right to make changes to the product at any
time which may not be reflected in this version of the
manual. Please contact your nearest distributor if you
require any further assistance.

It is the owner’s sole responsibility to install and use the
instrument and transducers in a manner that will not
cause accidents, personal injury or property damage.
The user of this product is solely responsible for
observing safe boating practices.

NAVICO HOLDING AS AND ITS SUBSIDIARIES,
BRANCHES AND AFFILIATES DISCLAIM ALL LIABILIT Y
FOR ANY USE OF THIS PRODUCT IN A WAY THAT MAY
CAUSE ACCIDENTS, DAMAGE OR THAT MAY VIOLATE
THE LAW.

Governing Language: This statement, any instruction
manuals, user guides and other information relating
to the product (Documentation) may be translated
to, or has been translated from, another language
(Translation). In the event of any conflict between any
Translation of the Documentation, the English language
version of the Documentation will be the official version
of the Documentation.

This manual represents the product as at the time
of printing. Navico Holding AS and its subsidiaries,
branches and affiliates reserve the right to make
changes to specifications without notice.

Copyright

Copyright © 2010 Navico Holding AS.

Feedback from you

Your feedback is important and helps Navico ensure
that this manual is a valuable resource for all marine
technicians. E-mail your comments or suggestions about
this manual to the following address:
[e-mail]

NEP-2 Installation Manual | 1

2 | NEP-2 Installation Manual

Compliance Statements

The NEP-2 complies with the following regulations:

• FCC Part 15

• CE compliant per EN60945

• C - Tick

For more information please refer to our websites:
www.simrad-yachting.com and www.lowrance.com

The equipment named in this declaration, is intended for
use in international waters as well as coastal sea areas
administered by countries of the E.U. and E.E.A.

Warning

The user is cautioned that any changes or modifications
not expressly approved by the party responsible for
compliance could void the user’s authority to operate the
equipment.

This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant

to Part 15 of the FCC rules. These limits are designed

to provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
the interference will not occur in a particular installation.
If this equipment does cause harmful interference to
radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the
following measures:

Reorient or relocate the receiving antenna •

Increase the separation between the equipment and •
receiver

Connect the equipment into an outlet on a circuit •
different from that of the receiver

Consult the dealer or an experienced technician for •
help

NEP-2 Installation Manual | 3

Industry Canada

Operation is subject to the following two conditions:

(1) this device may not cause interference, and

(2) this device must accept any interference, including
interference that may cause undesired operation of the
device.

Warranty

The warranty card is supplied as a separate document.

In case of any queries, refer to our websites:
www.simrad-yachting.com and www.lowrance.com

Contents

Introduction .................................................. 5

Parts List .....................................................5

Required tools and supplies ............................5

Installation .................................................... 6

Mounting location ..........................................6

Mounting the NEP-2 module ............................7

Wiring the NEP-2 ........................................... 8

Power .......................................................... 8

Ethernet .................................................... 10

Cables ....................................................... 10

NEP-2 network connection example ............... 11

Trouble shooting .......................................... 12

Specications .............................................. 13

Dimension drawings .................................... 14

4 | NEP-2 Installation Manual