Lovett s Electronics TX99 User Manual

PLEASE READ THESE

VERY IMPORTANT NOTES

1.) CHECK FOR IRRITATION ON A REGULAR BASIS. Even
though the shock probes are blunt, some dogs can get irritated
in as little as 2 days of constant use. If your dog is of the
stubborn type and has to wear it all of the time, shift it around
on different parts of the neck.

2.) Do not use on a dog if another dog is in the same kennel.
Dogs love to chew on things and a chewed collar is not covered
under warranty and is usually not repairable.

3.) We need to stress the fact that you install the battery as per
instructions. Terminal end (snap end) first then push on the
rear until it’s seated in the compartment. The battery pads are
very reliable and should last indefinitly if you follow the
instructions. Putting the battery straight in will fold over the
nickle foil and require repairs.

4.) Remember to use only DURACELL brand batteries. Any
good alkaline battery will work, but we have molded this unit for
Duracell battery dimensions. A longer battery will deform the
contact pads. If you choose to use another brand, stay with the
type you selected or one of equal length.

HT99 & LT99 BEEPER /TRAINER COMBO

INSTRUCTIONS & WARRANTY INFORMATION

WARRANTY

Lovett’s Electronics warrants these units to be free of defects in
materials and workmanship for a period of one year. Lovett’s
Electronics will promptly repair or replace, as it deems most
suitable, any product which is defective in material or
workmanship without charge for parts and labor provided the
product is returned to :
Lovett’s Electronics
840 E. Pinckley St.
Brazil, Indiana 47834
[phone]
All costs associated with the shipment of the product is the
responsibility of the purchaser. Enclose $6.00 for shipping and
handling and a dated copy of receipt or cancelled check. This
warranty does not cover defects caused by improper handling,
maintenance or abnormal use, alterations or accidents

The HT99 and LT99 beeper/trainer combo is a
new approach to an all in one unit. It is a fully
integrated system that uses some of the built-in
motion detector features of a beeper to control the
trainer. It can be programmed by the user to not
allow it to shock if the dog is standing still (on point),
which is one of the easiest ways to ruin a good bird
dog. It is compact, lightweight and both the receiver
and transmitter units are completely waterproof. It is
built in the USA under close inspection an tight
quality control.