
Losi® (LOSB9625)
Intelligent LiPo Balancer for 2-6 Cell LiPo Batteries
Specifications:
o Balances 2S to 6S LiPo batteries
o Balances discharge current of 300mA
o Voltage tolerance for cells is (+/-) 0.02V
Operational Process:
1. Read all safety precautions prior to use.
2. You can use the Intelligent Balancer when using a non-balance charger. It is
very good to perform maintenance balancing after each use.
Note: The Intelligent Balancer will NOT always fully balance a LiPo
battery during the time of a non-balance charge.
significantly out of balance, it may take 24 hours or more to rebalance a
battery.
3. Select the appropriate adapter for your LiPo balance lead. (See adapter chart)
4. See picture below
If a battery is
5. Connect the wire harness to the Intelligent Balancer.
Note: Label is marked with Positive (+) and Negative (-). The black
wire should be aligned and connected to the right as below.

6. Connect the Balance lead on your battery pack to the appropriate connection
on the adapter. Notice that each adapter has multiple connectors with the
cell count printed on the circuit board. Select your adapter and plug into the
wiring harness.
Note: When connecting the Losi balance plug for 2S or 4S there is one more
pin than the TP/Flight Power adapter provides. Connect the Balance lead
keeping to the LEFT while plugging into the adapter.
7. Once connected you will see the balancer count the number of cells. After the
initial count the balancing begins. The Blue LEDs will flash indicating the
balancing in progress.
Note: When the blue LED no longer blinks the battery is balanced.
8. The display shows you the cell number, and to the right, that cell’s voltage.
Safety Precautions:
1. Read all safety precautions prior to use.
2. This balancer does not replace a good balance charger.
3. This device will stop discharge balance at 3.2V per cell and turn the display
off at 3.0V per cell.
4. Do not charge or discharge any battery without a responsible adult present.
5. Do not disassemble or make modifications to this device.
Adapter Chart:
Adapter 2308 Adapter PQ Adapter Flight Power/ TP
ALIGN HYPERION LOSI
DUALSKY POLYQUEST THUNDER POWER
E-flite E-TEC FLIGHT POWER / EVO
ELECTRIFLY POLY RC APEX
HEXTRONIC XCITE MPX
COMMON SENSE MAXAMPS
AIR THUNDER TRUE RC
ESKY IMPULSE
VENOM
TENERGY