LOREX Technology SG7520 User Manual
4. Camera Specifications
H O M E & B U S I N E S S S E C U R I T Y
Image Device 1/4” Interline CCD
Effective Pixels NTSC:512Hx492V(252K)
PAL:512Hx582V(298K)
Scanning System
Resolution
Shutter Speed
S/N Ratio
Sync. System
Min. Illumination
White Balamce
Video Output
Lens
Power Supply
Power Consumption
Operating Temp
Operating Humidity
2:1 interlace
NTSC: 525 Lines
PAL: 625 Lines
Horizontal 420 TV lines
NTSC: 1/60 ~ 1/100,000
PAL: 1/50 ~ 1/100,000
More than 48dB (AGC off)
Internal
0.1 LUX @F1.2 (no LED)
0 LUX (with LED)
AWB
1.0 Vp-p (75 ohms)
Fixed Lens (3.6mm)
DC 12V ± 10%
100mA (LED OFF)
160mA (LED ON)
14°F ~ 122°F
(-10
°~ 50°C)
90% HM Max.
It’s all on the web
Product Information
User Manuals
Quick Start Guides
Specification Sheets
Software Upgrades
Firmware Upgrades
COLOR DAY/NIGHT
CCD BULLET CAMERA
WITH AUDIO
Model: SG7520 Series
SG7520 (NTSC)
SG7520P (PAL),
Refer to Spec Sheet for specific UPC
and Packaging Configurations.
Dimensions:
VISIT
www.lorexcctv.com
Quick Set-up Guide
LOREX Technology Inc.
Copyright © 2007 LOREX Technology Inc. As our
products are subject to continuous improvement,
LOREX and its subsidiaries reserve the right to modify product design, specifications and prices, without
notice and without incurring any obligation. E&OE
1. Package Contents 2. Installing the Camera 3. Camera Diagram
1 x 1/4” CCD Color
Day/Night Camera
1 x Camera Stand
1 x 100’ (30m) DIN
Extension Cable
Features:
• 1/4” advanced CCD image sensor
provides superior image quality.
• Excellent low light sensitivity with12
infrared LED illuminators*.
• Professional Grade Weatherproof**
camera.
• 100 ft. (30m) cable included.
• Color video by day, automatically
switches to B&W at night.
* Night Vision Range up to 30ft. (10m) in ideal conditions.
** IP64, Not intended for direct exposure to rain, snow or
water.
1. Attach the camera to the supplied stand. Mount
the camera stand to the desired mounting surface
2. Aim the camera. Remove the protective film from
the lens.
Lift the plastic tab on
the lower edge of
the camera to
remove the
protective film.
3. Connect the 100ft Extension cable to the camera:
Connect the other end of the 100ft Extension
Cable to the Observation System or DVR.
NOTE:
Confirm that the arrows on the DIN
Extension cable are aligned with the Camera
Cable and Observation system ports when
connecting the cable. If the pins in the DIN Cable
are bent, the Camera will NOT function
Cameras with 6 Pin DIN connections
draw power from the Observation
System or DVR.
Additional power adapters are not
needed for these cameras.
Infra-Red
LEDs
Camera
Lens
Microphone
Adjustable
Stand
DIN Input
Cable
System Connection Diagram:
Note:
Test the cameras prior to selecting a permanent
mounting location by temporarily connecting the
Cameras and Cables to the Observation System
or DVR.
Loading...