Lorex LW2004AC1 Quick Start Manual

LW2004AC1 SERIES ADD-ON CAMERA
Quick Start Guide
Contents:
Power Adaptor
TIP
Before you install the camera, carefully plan where and how it will be positioned, and where you will route the cable that connects the camera to the power adaptor.
Avoid installing in a location which requires the wireless signal to pass through cement, concrete and metal structures.
Camera
Stand
Powering up the Camera
1. Screw the camera stand into the stand mounting hole at the back of the camera, and place the camera on a flat surface.
2. Connect the AC power connector from the power adapter into the AC adapter port on the side of the camera.
3. Plug the power adapter into a power outlet.
4. Press and hold the power button at the top of the camera for 3 seconds to power on the camera.
This will reduce the transmission range.
SIMPLY AWARE
Power Adapter
NOTE:
• Only use the included power adapter to power the camera(s).
Pairing up Cameras
1. Make sure the camera you would
like to pair up is powered on.
2. Press the MENU button on the monitor to enter the menu screen.
3. Press the buttons until the PAIRING icon is highlighted and press OK.
4. Select the channel you wish to pair up the camera to by pressing the
buttons.
5. Press OK.
6. Press and hold the PAIR button on the side of the camera until the
monitor displays “Device Found”
indicating that the camera has been
successfully paired with the monitor.
2
3
4
Monitor (not included)
5
Camera
Camera
Power Outlet
AC Adapter Port
6
NOTE:
• The monitor can connect to up to 4 cameras.
TIPS
• The camera and monitor should be around
1ft. apart during the pair up process.
• Immediately after successful pairing, move the camera and monitor apart to avoid speaker
feedback.
FOR MORE INFORMATION:
www.lorextechnology.com
LW2004AC1 QSG_EN_R1 Page 1
Loading...