Lorex LPOE591201 Quick Setup Manual

Power Over Ethernet (PoE)
LPOE591201
Quick Setup Guide_R1
Power over Ethernet (PoE) technology delivers both data and electrical power over a single Ethernet network cable (RJ45). PoE allows you to place your network (IP) cameras, IP telephones, wireless LAN access points, remote network switches, and other devices wherever you want, regardless of proximity to a power outlet.*
When using a non-PoE network (IP) camera or other non-PoE network device, an Injector and Splitter are needed.
LPOE591201 includes the following:
1 - Power Injector 1 - Splitter 1 - Power Cable
Quick Set up:
1 2 3
Plug the PoE Injector to a power outlet.
* Maximum distance of 328 ft (100 m) using a standard RJ45 Ethernet cable.
Connect one end of an Ethernet cable (not included) to an empty LAN port on your network router or switch. Connect the other end of the Ethernet cable to the Data In port on the PoE Injector.
Note: The LAN port on your router/switch should be a non-PoE port. If you are using a PoE router/switch, you do not need to use the PoE injector, only the splitter.
On the Splitter, select the voltage that matches the voltage required for your camera: 12V, 9V, or 5V.
Page 1
FOR MORE INFORMATION
WWW.LOREXCCTV.COM
Power Over Ethernet (PoE)
4 5 6
LPOE591201
Quick Setup Guide_R1
Connect an Ethernet cable (not included) from the Power+Data Out port on the PoE Injector to the Power+Data In port on the Splitter.
Connect an Ethernet cable (not included) from the Data Out port on the Splitter to the Network/LAN port on the non-PoE network (IP) camera.
Rear
Connection:
Non PoE Router/Switch Power Injector
Rear
Front
Splitter
Connect the power cable from the Splitter to the power port on the camera.
Power
Rear
Non PoE IP CameraEthernet Cable
Page 2
For a wide range of cameras and accessories including Network Cameras, Digital Wireless Cameras, Dome Cameras, Extension Cables and Connectors, please visit us at:
www.lorexcctv.com Toll free: 1-888-42-LOREX
Loading...