Lorex Edge Touch Screen Monitor Quick Start Manual

Edge Touch Screen Monitor Setup

The USB cable must be connected to the monitor’s USB port
and the DVR’s USB port to enable the touch screen function.

DVI Port

USB Port

Power Port

AC power cord

DVI cable

16 channel configuration shown above. 8 will have the respective number of video inputs

USB cable

AC Power Cord: Provides power to the touch screen monitor.
DVI Cable: Transmits video from the DVR to the touch screen monitor.
USB Cable: Enables the DVR to recognize touch gestures on the monitor.

Step 1 of 3: Connect the cables

www.lorextechnology.com

1

Power LED

Power Button

Before you start:

1. Turn on your Edge DVR.

2. Make sure your monitor is turned on by pressing the Power Button.

3. Wait for the DVR to boot into the main viewing mode.

Tap

Tap an icon (i.e. Menu icon) in the
system tool bar to open a menu.

Scroll

Swipe your finger to scroll through
menus, or to adjust individual values. For

example, navigate to Menu>LAN ( ).
Then, swipe your finger over the numbers
to adjust the IP values.

Slide

Slide your finger on a desired channel to
open the channel slider. Slide your finger left
or right to select the desired channel
number. Release your finger from the screen
to confirm the selection.

Tap C to exit a menu

www.lorextechnology.com

Step 2 of 3: Power on the Monitor

• Press the power button to turn the monitor on.

Step 3 of 3: Test the touch screen gestures: Tap, Scroll, Slide

2