Lorex DXR4280UQ Hard Drive Installation
INSTALLATION OF THE HARD DISK DRIVE
IN THE DXR4280UQ (80 GB HDD)
PLEASE MAKE SURE THAT YOU SET THE HARD DRIVE TO MASTER. FOR MORE
INFORMATION PLEASE CONTACT THE MANUFACTURER OR REFER TO THE
OWNER’S MANUAL
The HDD serves the same purpose in a DVR as a video cassette does in a VCR.
However, installing the HDD is a bit more complicated. Please follow the next steps
carefully in order to ensure proper installation.
The compartment located on the front panel of the DVR is the removable Cartridge Casing in which you
insert the HDD. The various parts of the Cartridge Casing are labeled for your reference.
1. Remove the Cartridge Casing from the DVR
Lift the Handle and pull towards you. The Cartridge Casing will slide out of the DVR.
Cartridge Casing
3 2
YOU MAY FIND THAT THE CARTRIDGE CASING IS LOCKED. IN THIS CASE, SKIP
AHEAD TO STEP 8 TO FIND INSTRUCTIONS ON UNLOCKING THE CABINET, THEN
RETURN TO STEP 2.
2. Remove the Cover from the Cartridge Casing
a) Unclip the release latch with the word “OPEN” printed beside it by gently pushing on the latch.
b) Slide the cover off the Cartridge Casing.
1
1. Keyhole
2. LED indicator lights
(Power indicator & HDD Access indicator)
3. Handle
3. Connect the 80 GB HDD into the Cartridge Casing
Take the Hard Disk Drive and Connect the two cables from the bac k of the Cartridge Casing to the HDD.
The cables should be pushed in firmly, but not forcibly.
The 4 Pin connection is the DC Power cable, and the wider cable is the standard Hard
Drive IDE type connection.
4. Secure the HDD in the Casing
Use screws and tighten them, positioning the HDD into place. Thi s step is optional, but it is recommended.
5. Slide the top Cover over the Cartridge Casing
Slide the Cover forward over the Cartridge Case. Ensure it is se cured in place over the release latch.
6. Reinsert the Cartridge Casing into the DVR. Fully insert the Cartridge Case into the DVR.
7. Lock the Cabinet. Lock the cabinet by turning the key clockwise.
A
(locked)
B
(unlocked)
If you need to unlock the cabinet, turn the key counter-clockwise from the position shown above.
IF YOU DO NOT LOCK THE CABINET, THE DVR SYSTEM WILL NOT FUNCTION
PROPERLY.
8. Turn ON the DVR .The system will boot up and will detect the Master hard drive
PLEASE MAKE SURE THAT YOU SET THE HARD DRIVE TO MASTER. FOR MORE
INFORMATION PLEASE CONTACT THE MANUFACTURER OR REFER TO THE
OWNER’S MANUAL
www.lorexcctv.com
Loading...