Lorex ACCYARD1 User Manual
Quick Start Guide
ACCYARD1
Security Yard Sign
Package Contents
• Yard Sign with Solar LED Light and Rechargeable Battery
• Mounting Screws & Drywall Anchors (×2)
• Sign Post (3 pieces; 1 pre-attached to sign)
Dimensions
11.8" / 300mm
9.2"
233mm
33.6"
853mm
Getting Started
• Before installing the sign, press the power button on the underside of the solar
LED light. This will allow the battery to charge during the day and turn on the
light at night. It is recommended to check that the light comes on in a dark room
before installing the sign.
• Choose a location for the sign with plenty of direct sunlight exposure. Do not
install in a covered or shaded area.
• The solar panel requires at least 3-4 hours of direct sunlight per day.
Performance dependent on temperature and light exposure.
• For wall mounting, ensure you can safely drill into your selected mounting
location.
Safety Precautions
• The solar panel may require periodic cleaning to ensure it is capturing light
effectively. Use a damp cloth only. Do not use chemical cleaners.
• Do not dispose of the battery in regular garbage. Handle as hazardous waste.
Dispose according to local hazardous waste programs.
Installation (YARD SIGN)
Choose a location for the sign with plenty of direct sunlight exposure.
Do not install in a covered or shaded area.
To install the sign in the ground:
1. Wearing protective
work gloves, push the
pointed end of Bar #3
into the ground. The
pointed side of the
bar should point the
opposite direction that
the sign will face.
NOTE: If the ground is
especially solid, tap the
bar into place using a
rubber mallet.
2. Press the springloaded button on the
bottom of Bar #2 to
insert into the top of
Bar #3. Be careful not
to pinch your fingers
between the bars.
3. Press the springloaded button on the
top of Bar #2 to insert
into the top of Bar #1
(pre-attached to the
back of the sign). Be
careful not to pinch
your fingers between
the bars.
ATTENTION:
Figure 1 Figure 2
Bar #1
Bar #2
Bar #3
Spring-loaded
buttons
Pointed side should face
the opposite direction of
the sign
* Side view
Installation (WALL SIGN)
Choose a location for the sign with plenty of direct sunlight exposure.
Do not install in a covered or shaded area.
To install the sign on a wall:
1. Remove the fastening
screws (see Figure 2)
from the front of the
sign using a Phillips
head screwdriver (not
included). This removes
the back bar
to prepare the sign for
wall-mounting.
2. Drill holes for the
mounting screws and
plastic anchors (×2). The
holes must be level and
4.25” (108mm) apart
center-to-center.
3. Insert the anchors
firmly into the holes
(recommended to tap
anchors into place using
a rubber mallet).
4. Use a Phillips
screwdriver to insert
*
the mounting screws
into the anchors. Leave
approximately 5mm of
each screw outside of
the anchor (see Figure 3).
5. Line up the notches on the back of the solar LED light with
the protruding screws and push down on the sign to secure
it in place.
Copyright © 2018 Lorex Corporation
As our products are subject to continuous improvement, Lorex
reserves the right to modify product design, specifications and
prices, without notice and without incurring any obligation.
E&OE. All rights reserved.
ATTENTION:
108mm
Mounting
screws (×2)
Fastening
screws (×2)
Figure 3
5mm
Mounting
screw
www.lorex.com
4.25"
ACCYARD1_QSG_EN_R2
Plastic
anchors (×2)
Mounting surface
Plastic
anchor
Loading...