Lorex ACCANTO8 Quick Start Manual

www.lorexcctv.com

Directional Panel Antenna

Wireless Camera

Clear line of sight (estimated range up to 800 ft.)

Cable from Directional Panel Antenna

Wireless Receiver

Outdoor installation.

Indoor connection.

ATTENTION: Select a mounting location (wall, fence, etc.) prior to assembling the antenna. Fully extend the length of extension cable to

ensure the antenna will be an adequate distance from the receiver. Ensure you can safely drill into your selected mounting location. The antenna should be aimed directly at the camera with a clear line of sight, or wireless performance will be reduced.

CONTENTS

1. Panel Antenna (x1)

2. Mount (x1)

3. Screws (x2)

4. Anchors (x2)

5. 20 ft. (6 m) Antenna Extension Cable (x1)

SPECIFICATIONS

• Frequency: 2400 ~ 2500 MHz

• Max Gain: 9 dbi

• Connector: N Female

• Max input power: 10 W max.

• Wave impedance: 50 Ω (±5Ω)

• Weight: 0.62 lbs. (280 g)

• Dimensions: 4.2" 3.5" x 1.2" (107 mm x 90 mm x 30 mm)

2.4 GHZ DIRECTIONAL

WIRELESS PANEL ANTENNA

INSTALLATION GUIDE

USING THE DIRECTIONAL PANEL ANTENNA

English Version 1.0

Use the 2.4GHz Directional Wireless Panel Antenna to focus a wireless signal onto one specific camera in order to increase range of transmission (clear line-of-sight between the camera and the antenna is required). If you need to extend the range of more than one wireless camera

, please order the Omni-Directional Antenna (Lorex model

#ACCANTO8.)

ASSEMBLING THE ANTENNA

1. Remove the mounting plate from the back of the antenna and place on the surface you wish to mount the antenna. Mark the holes for

drilling.

2. Drill the holes. Fasten the mounting plate to the surface using the included mounting kit.

3. Remove the rubber cap from the bottom of the antenna and connect the Antenna Extension Cable.

4. Slide the antenna onto the mounting plate.

5. Run the extension cable to your camera or receiver.

MODEL:

ACCANTD9