Loopcomm Technology LP-9181A Users Manual

Wireless Signal Booster

&

9 dBi Directional Antenna

Quick Start Guide1.0.0

PLEASE READ THIS NOTICE BEFORE USING THE PRODUCT

Thank you purchase this product, before starting to use , please do read this
application notice and see how this product can be used in the most correct ways

© 2010

1. Warning Statement

Federal Communication Commission Interference Statement Federal Communications
Commission (FCC) Requirements, Part 15

1. Reorient or relocate the receiving antenna.

2. Increase the separation between the equipment and receiver.

3. Connect the equipment into an outlet on a circuit different from that to which the receiver

is connected.

4. Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions:
This device may not cause harmful interference. This device must accept any interference

received, including interference that may cause undesired operation.

FCC Caution:

This Transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter. This equipment complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with a minimum
distance of 20 centimeters between the radiator and your body. Unauthorized antenna,
modification, or attachments could damage the transmitter and may violate FCC regulations.

Regulatory information / Disclaimers:

Any changes or modifications (including the antennas) made to this device that are not
expressly approved by the manufacturer may void the user's authority to operate the
equipment.

1.1 Step1. What you will need to get started

Wireless 802.11b, 802.11g or 802.11n network
Wireless device to attach to this Booster

1.2 Step2. Check your package.

z Booster device base stand × 1
z 9 dBi Directional Antenna × 1
z Power Adapter × 1
z Quick start Guide × 1

2. Hardware description

Front Side:

Status LED: Display power status and data transmit status.

Input Connector:

3. Hardware installation