ASSEMBLY INSTRUCTIONS
ASSEMBLY TIPS:
1 . Remove hardware from box and sort by size.
2 . Please check to see that all hardware and parts are present prior to start of assembly.
3 . Please follow attached instructions in the same sequence as numbered to assure fast & easy assembly.
Warning!
!
1 . Don’t attempt to repair or modify parts that are broken or defective. Please contact the
store immediately.
2 . This product is for home use only and not intended for commercial establishments.
ASSEMBLY TIME
10 MINUTES
PARTS IDENTIFICATION
PART NAME
A
NOTE : PHILLIPS HEAD SCREW DRIVER IS REQUIRED IN THE ASSEMBLY PROCESS;
HOWEVER, MANUFACTURER DOES NOT PROVIDE THIS ITEM.
STEP 1
DRESSER
TOP DRAWER
FIGURE
BO OM DR WTT A ER
QTY
1PC
1.1) Unscrew the pull from the back of drawer front.
1.2) Align & fasten the pull to drawer front using screw
and fully tighten with Phillips head screw driver (NOT INCLUDED)
STEP 2
COMPLETE
FURNITURE TIPPING RESTRAINT
Injury may result from tipping furniture.
This restraint may protect against tipping furniture.
Do not allow children to climb on furniture.
This restraint is not a substitute for proper adult supervision.
Failure to detach this restraint before moving the furniture
may result in injury and damage.
This tip restraint must be attached to a wall
stud using long screw enclosed.
WARNING
STEP 2
STEP 1
Attach a bracket securely to the back top rail of the
furniture using short screw provided, through the
smaller hole.
Locate the other bracket on the wall over a wall
stud and two inches below the mounting bracket
secured to the back of furniture. Attach the
wall stud using the long screw provided, through the
smaller hole.
A L W L
STEP 3
Place the furniture into position so both mounting brackets are vertically in line. Lace the end of the
restraint strap through the larger hole in each mounting bracket. Bring both ends together and slide
the flat end through the locking end and draw it through until all slack is removed. Confirm that the
strap is securely laced and locked.
L WAL
Loading...