INSTALLATION INSTRUCTIONS
READ IMPORTANT SAFETY TIPS BEFORE PROCEEDING WITH INSTALLATION
SAFETY TIPS
Turn fixture off! (Place wall
switch in off position, if fixture
has built-in switch or chain pull,
switch or pull chain so fixture is
off.)
1
cross bar
ATTACH cross bar to outlet box with outlet box
screws (8-32x1/2, 2 slotted screws provided).
outlet box
screws
ground
wire
Next - go to the main fuse box.
If your fuse box has an ON/OFF
switch, simply place main power
switch in OFF position.
outlet box
3
mounting
screw
Screw-in type fuses - unscrew
the fuse or fuses that control the
power to the fixture or room you
are working in.
2
ground
wire
wire connectors
(not provided)
CONNECT THE WIRES. NOTE: Attach black fixture wire to black supply wire, white fixture wire to
white supply wire. Do not mix them up. Use
approved electrical tape or wire connectors (not
provided). Connect bare fixture ground wire to
ground wire from outlet box. NEVER CONNECT
GROUND WIRE TO BLACK OR WHITE POWER
SUPPLY WIRES.
washer
cross bar
POSITION THE FIXTURE over the outlet box and
secure in place with the mounting screw (1/4-20x1, 1
provided). Screw bulb into socket (if installing fluorescent fixture simply insert bulb into socket). Be sure to
use bulb with wattage no greater than specified for
this fixture.
INSTALLATION INSTRUCTIONS
4
PLACE DIFFUSER on fixture base, then place bar grill or frame (depending on fixture model) over diffuser
and attach to base with mounting screws (8-32x1/2, 4 combination head screws provided).
NOTE: On models with hood, attach diffuser to base with one combination head mounting screw at center
top of base only. Place hood over diffuser and secure to base with remaining three mounting screws.
NOTE: Outdoor wall fixture MUST be caulked with an acrylic caulk where base of fixture meets mounting
surface. This provides a water tight seal when fixture is installed.
mounting screws
bar grill diffuser
caulk
base
5
ON MODELS WITH HOOD, attach to wall with reflector up. Hood is to be placed above reflector as
shown.
hood
diffuser
reflector
wall
FOR FLUORESCENT FIXTURES ONLY---COLD WEATHER STARTING INFORMATION: For temperatures below 25°
leave the PL( lamp(s) on continuously - starting with warm lamps. NOTE: If lamp starting becomes a problem in any
cold weather applications; remove the lamp(s) from the fixture - bring the lamp(s) indoors so that they become warm then re-install the lamp(s) into the fixture and leave the fixture on continuously. Do not place lamp(s) in an oven,
microwave or similar heat producing device.
Loading...