
Ì«®² ÑÒ ½±³°«¬»®ò
Û²½·»²¼¿ »´ ±®¼»²¿¼±®ò
-±«- ¬»²-·±²ò
Ó»¬¬»¦ ´Ž±®¼·²¿¬»«®
Ô·¹«» ± ½±³°«¬¿¼±®ò
ËÍÞ °±®¬ò
д«¹ ·² ËÍÞ ³·²·ó®»½»·ª»® ·²¬± ½±³°«¬»®Ž-
ݱ²»½¬» »´ ³·²·®®»½»°¬±® ËÍÞ ¿´ °«»®¬±
ËÍÞ ¼»´ ±®¼»²¿¼±®ò
-«® ´» °±®¬ ËÍÞ ¼» ´Ž±®¼·²¿¬»«®ò
Þ®¿²½¸»¦ ´» ³·²·®7½»°¬»«® ËÍÞ
Ô·¹«» ± ³·²·ó®»½»°¬±® @ °±®¬¿ ËÍÞ
¼± ½±³°«¬¿¼±®ò

This e quipment has been tested and found to comply with the limits for a Class B
device, pursuant to Part 15 of the FCC R ules. These limits are designed t o p
reasonable protection against harmful interference in a residential installation.
equipment generates, uses and can radiate radio f requency energy and, if not i
used in a ccordance with the instructions, may cause harmful interference to
communications. However, there is no guarantee that interference will not o
particular installation. If this equipment does cause harmful interference to r
television reception, which can be determined by turning the e quipmento ff and on, t
is encouraged to try to correct the interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separationbetween the equipment andreceiver.
- Connect the equipment into an outlet on a circuit different from that
to which the receiver isconnected.
- Consult the dealer or an experiencedradio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the
responsible for compliance could void theuser's authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the f
two conditions:(1) This device may not cause harmful interference, and (2) this device
accept a ny interference received, including interference that may cause u
operation.
This equipment complies with FCC RF radiation exposure limits set forth for an u
environment. To maintain compliance with F CC RF exposure compliance r
please avoiddirect contact to the transmitting antenna during transmitting
.