According to the European WEEE directive , electrical and
electronic equipment must not be disposed with consumers waste.
Its components must be recycled or disposed apart from each other.
Otherwise contaminative and hazardous substances can pollute
our environment.
You as a consumer are committed by law to dispose electrical and electronic
devices to the producer, the dealer, or public collecting points at the end of the
devices lifetime for free. Particulars are regulated in national right. The symbol
on the product, in the user's manual, or at the packaging alludes to these
terms. With this kind of waste separation, application, and waste disposal of
used devices you achieve an important share to environmental protection.
1.0 Safety Instructions
Put the Device always on a stable and straight Surface. In case of
falling it can be damaged.
Don’t place the Device into direct Sunlight or in Places with high
Temperature. This can damage the Device or shorten his average
useful Life.
Don’t place it in the near of Heat Sources, like Radiators or other
heat producing Devices.
Don’t expose the Device to Rain, Water, Wetness or high Humidity.
Don’t place it in the Bathroom or the Kitchen in the near of a Sink.
Avoid the direct Contact with Water.
Don’t try to open the Device.
Prior to the first use of our product make a backup of your data.
We are not liable for any loss of data, unless you can accuse us
intention or gross negligence.
In any case, liability for loss of data is limited to the effort that is
necessary to restore from existing backup copies.
Congratulations to the Purchase of LogiLink WL0145!
Please read the Manual and Safety Instructions before using the
product for the first time. Otherwise damage can be the result.
- 1 -
2.0 Introduction
The WL0145 Wireless N 150Mbps USB Adapter is designed for
SOHO users.
It allows users to enjoy Wireless network and easy wireless
security connection.
2.1 Specification
Complies with IEEE802.11b/g/n standards
High transfer data rate – up to 150Mbps
Supports 64/128-bit WEP, WPA, WPA2, WPA-PSK and
WPA2-PSK Encryption
Supports WiFi Protection Setup (WPS)
Supports USB 2.0/1.1 interface
Supports Windows XP/Vista/7/8, Linux and MAC OS
2.2 Package Contents
1 x Wireless N USB Adapter
1 x Quick Installation Guide
1 x CD (Driver + Manual)
2.3 Wireless USB Adapter Overview
Wireless USB Adapter has the USB interface
and LED below.
USB Interface:
Connect the USB Interface to a USB port on
your computer.
LED:
The LED stays lighted to indicate WLAN link
established and active.
- 2 -
3.0 Installation
The following instructions will
guide you to through the process
of installing the Wireless USB
Adapter.
1. Insert the Wireless N USB
Adapter into an empty USB
2.0 port of your computer
when computer is switched on. Never use force to insert the
card, if you feel it’s stuck, flip the card over and try again.
2. Once USB dongle connected to computer, Windows will
detect that new hardware has been added, and start the
"Found New Hardware". Click on "Cancel" to continue.
For Windows XP
For Windows 7
- 3 -
3. Please insert the AUTORUN CD into your CD-ROM drive.
The CD should auto-start, displaying the following window. If it
does not start, click on Start-Run and type in CD:
\autorun.exe (where CD is the drive letter of your CD-ROM
drive.) Click "Driver Installation".
For Windows 7 / Vista User only
For Security reasons Windows 7 / Vista requires the installer
program to have administrator privileges so the new policy called
"User Account Control" has been introduced in Windows 7 /
Vista. If UAC is enabled Windows pops up a window "User
Account Control" Windows need your permission to continue.
User needs to Click "Yes / Allow" to proceed with the installation.
- 4 -
4. Here you can choose
if you want to install
the Drivers and the
Ralink Software or
only the Drivers.
Click “Next” to
continue.
5. Click “Install” to start
the Installation. The
Installation Progress
is shown in a Status
Bar.
6. Click “Finish” to
complete the
Installation.
4.0 Operation
Windows WLAN Tool
1. If you have installed only the Drivers you can connect to a
WLAN with the Windows XP/Vista/7/8 own WLAN Tool.
- 5 -
2. Click the “Connect” Button,
enter and confirm your
Password.
Ralink Software - General
1. If you have installed the Drivers and the Software you can
connect to a WLAN with the Ralink Utility. You’ll find the Icon
in the Systray.
2. Double-click the icon or right click the icon and then select
“Launch Config Utility” to launch the utility. The RaUI Main
Window appears like shown below.
- 6 -
3. Clicking the expanding icon can change to the full mode as
shown below:
Ralink Software - Functions
Wi-Fi Direct
WL0145 supports “WiFi
direct”. With this
Function you are able to
connect directly to other
Devices which also
supports “WiFi direct”
without using a Router.
WPS
WL0145 supports WPS.
Click on Profile and then
on WPS Configuration.
WPS offers two
- 7 -
Methods:
1. PBC (Push Button Configuration) Method (recommended)
The Device to which you are connecting must have a WPS
Button available on its external Casing or as Part of its
Software Interface.
2. PIN Method
Use this Method if the Device to which you are connecting
has no WPS Button.
Config Mode = Enrollee
If the Device to which you are connecting requires a PIN.
Config Mode = Registrar
If the Device to which you are connecting provides a PIN.
AP Mode
The device also can serve as an access point to transmit wireless
signals and create wireless network, allowing other wireless
clients to access the network.
To switch to AP mode, right-click the Ralink utility icon and click
“Switch to AP Mode”.
For advanced settings and other features of this Wireless N USB
Adapter, please refer to user manual enclosed in supplied
CD-ROM.
CE Declaration:
This device corresponds to EU directive 1999/5/EC:
With the CE sign Logilink®, a registered trademark of
the 2direct GmbH ensures, that the product is conformed to the
basic standards and directives. These standards can be
requested online on www.logilink.com. All trademarks and
registered brands are the property of their respective owners.
- 8 -
Loading...