How it Works
Logik
Loading...
LGHOBX10
Installation Manual
24 pgs2.8 Mb0

Logik LGHOBX10 Installation Manual

Built-in Gas Hob
Instruction / Installation Manual LGHOBX10
GB
LGHOBX10_Vestel_IB_110419_flo.indd 1 20/04/2011 4:02 PM
LGHOBX10_Vestel_IB_110419_flo.indd 2 20/04/2011 4:02 PM
Contents
The Main Unit .............................................................................................................................................................5
Control Panel ..............................................................................................................................................................5
Overall Dimensions ...............................................................................................................................................16
Check the Hob After Installation & Before Using .......................................................................................16
Pressure Testing .....................................................................................................................................................16
Natural Gas...............................................................................................................................................................17
LP Gas ........................................................................................................................................................................17
Method ...................................................................................................................................................................... 17
LGHOBX10_Vestel_IB_110419_flo.indd 3 20/04/2011 4:02 PM
4
Main Unit
Unpacking
Remove all packaging from the unit. Retain the packaging. If you dispose of it please do so according to local regulations.
The following items are included:
Pan Support (Left/Right) × 2
P.N.: Left - 37002036 Right - 37002037
LPG Replacement Rating Plate Sticker × 1
P.N.: 20628175
100 mm Burner Ring × 1
P.N.: 37001476
Fixing Plate × 4
P.N.: 37001970
100 mm Burner Cap × 1
P.N.: 37001479
75 mm Burner Ring × 2
P.N. 37001477
Screw × 4
P.N.: 37002652
75 mm Burner Cap × 2
P.N.: 37001480
55 mm Burner Ring × 1
P.N. 37001478
LPG Nozzle × 4
P.N.: Ø 100 37001482 Ø 75 37001483 Ø 55 37001484
Seal × 1
P.N.: 62000705
55 mm Burner Cap × 1
P.N.: 37001481
Instruction / Installation Manual
P.N.: 52036601-V2
LPG Nozzle Installation Guide × 1
P.N.: 52007667
Thank you for purchasing your new Logik Built-in Gas Hob.
You must read this manual in order to fully understand how to operate it correctly.
This unit MUST be installed by a competent and registered engineer (Gas Safe in the UK). Please allow the installer to view the installation section of this manual.
Read all the safety warnings carefully before use and keep this manual for future reference.
If items are missing or damaged, please contact Partmaster (UK only).
Tel: 0844 800 3456 for assistance.
LPG Conversion Kit:
LGHOBX10_Vestel_IB_110419_flo.indd 4 20/04/2011 4:02 PM
5
Product Overview
The Main Unit
Control Panel
1. Standard burner (75 mm)
2. Control panel
3. Ignition button
4. Large burner (100 mm)
5. Small burner (55 mm)
1
1
2
3
5
4
To select upper right burner
To select upper left burner
To select lower left burner
To select lower right burner
LGHOBX10_Vestel_IB_110419_flo.indd 5 20/04/2011 4:02 PM
6
Before Using Your New Hob
Before using your new hob, please:
• Read this manual fully taking special note of the ‘Safety Warnings’ section.
• Plug the hob into the electricity supply and turn it on so that the ignition circuit will work.
Lighting the Hob
1. Choose the control for the burner you want to use.
2. Press the control down gently and turn it anti-clockwise to the large flame symbol
while pressing the ignition button
. The ignitors on all burners will spark.
Only the burner you have selected will light.
3. Once the burner is lit, release the ignition button but keep holding the control for approximately 5 – 10 seconds after the flame has lit to ensure the Flame Supervision Device (FSD) operates.
4. With the control no longer pressed in, you can continue turning it towards the small flame symbol, depending on the setting you want to cook with. Always adjust the flame for cooking between the small and large flame, never between the large flame and off.
5. Control the flame so that it does not spread out beyond the side of the pan, as the outer part of the flame is much hotter.
O
High
Low
• If the burner does not light up within 15 seconds, turn the control off and wait for at least one minute before trying again.
• To switch the burner off, turn the control clockwise to the 0 position. After use, always turn the controls to the off position.
If the flame goes out turn the burner off, wait 60 seconds and then repeat the procedure above.
This appliance is for cooking purposes only. It must not be used for other purposes, e.g. room
heating.
✓
Gentle simmering, slow warming, reheating and rapid simmering
Boiling, sauté and searing – maximum heat
The use of a gas cooking appliance results in the production of heat, moisture and products of combustion in the room in which it is installed. Ensure that the kitchen is well ventilated especially when the appliance is in use: keep natural ventilation holes open or install a mechanical ventilation device (mechanical extractor hood). Prolonged intensive use of the appliance may call for additional ventilation, e.g. opening of a window, or more effective ventilation, e.g. increasing the level of
mechanical ventilation where present.
LGHOBX10_Vestel_IB_110419_flo.indd 6 20/04/2011 4:02 PM
7
If the Flame is Irregular
• If the flame is yellow or irregular, check that the burner parts, including the burner cap, are:
• Clean and dry.
• Positioned correctly. See ‘Replacing the Burners’.
• Also see ‘Hints and Tips’.
Flame Failure Safety Feature
The flame supervision device (FSD) probe cuts off the gas supply to the burner if the flame is blown out.
When lighting the burner, hold down the control for approximately 5 – 10 seconds after the burner has lit. Releasing the control too soon will extinguish the flame.
If the flames are accidentally extinguished, turn off the burner and do not try to light it again for at least one minute (to allow the gas to disperse).
If the Burner Does Not Light
If the burner does not light, check that:
• The hob is switched on.
• The gas is turned on.
• You have held down the control for at least 5 – 10 seconds.
• The ignitors are sparking. If the ignitors are not sparking, they may be dirty or wet. Clean them gently with a
small nylon brush such as a toothbrush as shown below.
Ignitor
Flame failure probe
To avoid damage to the ignition circuit NEVER light the hob when the burners are not in place.
Burner Cap
Electrode
Burner Ring
Electricity Failure
If there is an electricity failure, you can still use your hob. Light the burners by holding an ignition source (e.g. candle lighter) close to the side of the burner and turning the control to the High position to light the gas. The controls must still be held down for 5 – 10 seconds after the burner has lit. Releasing the controls too soon will extinguish the flame. Adjust the controls as required.
LGHOBX10_Vestel_IB_110419_flo.indd 7 20/04/2011 4:02 PM
8
• Do not use large saucepans or frying pans that overlap the edges of your hob as this can deflect heat onto your worktop and damage the surface.
• Always make sure saucepans are stable. Using very heavy saucepans may bend the trivet/pan support or deflect the flame.
• Always lift the cookware when removing from the hob, do not drag.
• When you need to boil, simmer or fry food, first set the temperature to the High position.
Once the food is boiling, reduce the temperature to maintain a steady heat to cook your food thoroughly. Doing this will reduce the cooking time.
• Pan sizes should be as per the table shown below.
Burners Minimum Diameter Maximum Diameter
Large (100mm) 22 mm 26 mm
Standard (75mm) 14 mm 22 mm
Small (55 mm) 12 mm 18 mm
Cookware Guidelines
To get the best out of your hob, follow these simple suggestions:
• Use saucepans with thick flat bottoms. Food in a saucepan with an uneven bottom will take longer to cook.
• Using a lid will reduce cooking times.
• When liquid comes to the boil reduce the temperature setting.
• Choose cookware of the proper size, material and construction.
• Minimise the amount of liquid or fat to reduce cooking times.
• Select the proper temperature setting for the cooking task.
Do not use cooking vessels on the hob that overlap its edges.
LGHOBX10_Vestel_IB_110419_flo.indd 8 20/04/2011 4:02 PM
Loading...
+ 16 hidden pages
Buy Points How it Works FAQ Contact Us Questions and Suggestions Privacy Policy Cookie Policy Terms of Use