Logik LDW45S12 Installation Instructions Manual

Slimline Dishwasher
Installation / Instruction Manual LDW45S12
3
Contents
Unpacking ..................................................................................................................................... 5
Installation .................................................................................................................................... 6
Product Overview ....................................................................................................................... 10
Internal View............................................................................................................................................................11
Wash Cycle Table ......................................................................................................................... 13
Before Operating ........................................................................................................................ 14
Adding Detergent or Detergent Tablet .....................................................................................15
Adding Rinse Aid ........................................................................................................................ 16
Loading the Dishwasher ............................................................................................................19
- Adjusting the Upper Basket .................................................................................................................... 20
- Loading the Upper Basket for 9 Place Settings ................................................................................20
- Hinged Cup Rack ........................................................................................................................................ 21
- Hinged Spikes .............................................................................................................................................. 21
- Loading the Lower Basket .......................................................................................................................22
- Loading the Cutlery Basket ..................................................................................................................... 22
Starting a Wash Cycle .................................................................................................................23
Changing a Programme ............................................................................................................. 23
At the End of a Programme ........................................................................................................ 23
Switching O the Unit ................................................................................................................ 24
Unloading the Dishwasher ........................................................................................................ 24
Delay Start ................................................................................................................................... 24
Half Load ..................................................................................................................................... 24
Cleaning After Use ...................................................................................................................... 25
- The Door and the Door Seal ................................................................................................................... 25
- The Control Panel .......................................................................................................................................25
- Filtering System ...........................................................................................................................................25
- Spray Arms .................................................................................................................................................... 26
4
Frost Precaution .........................................................................................................................26
Moving the Dishwasher .............................................................................................................26
Maintenance After a Prolonged Period of Non-Operation ..................................................... 26
Hints and Tips ............................................................................................................................. 27
Disposal of the Dishwasher ....................................................................................................... 29
Disposal of Packing Material ..................................................................................................... 29
Specications .............................................................................................................................. 30
Safety Warnings .......................................................................................................................... 31
5
Unpacking
Remove all packaging from the unit. Retain the packaging. If you dispose of it please do so according to local regulations.
The following items are included:
The Main Unit
Detergent Measuring Spoon x 1 1 full spoon = 20g (approx.)
P.N.: 673002200079
Instruction Manual X 1
P.N.: LDW45S12-003
U-shape Hose Holder X 1
P.N.: 673006200003
Salt Funnel X 1
P.N.: 673002200043
Measuring Cup X 1 60ml (approx)
P.N.: 673006200004
Water Supply Hose X 1
P.N.: 673000900060
Cutlery Basket
P.N.: .673002200080
Power
Delay Start
1/2 Load
3in1 Intensive Normal Eco Rinse GlassRapid
Thank you for purchasing your new Logik Slimline Dishwasher.
These operating instructions will help you use it properly and safely. We recommend that you spend some time reading this installation/instruction manual
in order that you fully understand all the operational features it offers. Read all the safety instructions carefully before use and keep this installation/
instruction manual for future reference.
If items are missing or damaged please contact Partmaster (UK only).
Tel: 0844 800 3456 for assistance.
This product has been wet tested to ensure correct operation. As a result some water may remain inside the unit. This is normal and safe. Remove any water droplets from the exterior
if necessary.
Condensation Strip X 1
P.N.: 675001300715
6
INSTALLATION
450
580
unit in mm
850
30
850
450
620
min.100
80
450
580
850
30
850
450
620
min.100
80
level
level
level
level
Power
Delay Start
1/2 Load
3in1IntensiveNormal Eco Rinse Glass Rapid
Power
Delay Start
1/2 Load
3in1IntensiveNormal Eco Rinse Glass Rapid
1. Please ensure the dishwasher is installed by a qualified technician. Refer to the tools required.
Power
Delay Start
1/2 Load
3in1Intensive Normal Eco Rinse Glass Rapid
Location
When selecting a position for your slimline dishwasher you should make sure the installation surface is flat and firm, and the room is well ventilated. Avoid locating your dishwasher near a heat source, eg. cooker, boiler or radiator. Extreme cold ambient temperatures may also cause the appliance not to perform properly. This dishwasher is not designed for use in a garage or outdoor installation.
Do not drape the dishwasher with any covering. When installing, ensure that free space is left at the sides.
2. Ensure there is clearance each side of the unit to allow slight sideways movement for servicing when required. Good levelling is essential for correct closure and sealing of the door. When the unit is correctly levelled, the door should not catch the inner liner on either side of the cabinet. The adjustable feet may be loosened or tightened in order to obtain the optimum levelling of the unit.
Installation
All parts removed must be saved to do the reinstallation in the future. Ensure the dishwasher is unplugged and empty. We recommend that 2 people handle the dishwasher during
installation.
7
INSTALLATION
3. If required, the worktop of the dishwasher can be removed. The height without the worktop is 820 mm, the minimum dimensions required to accommodate the dishwasher within fitted kitchen furniture units. Do not connect the unit to the mains socket before installation. Ensure you are not installing the unit right in front of the mains socket. This is to avoid potential damage to the back of the unit.
5. The worktop can be removed by removing the fixing screws located at the rear of the dishwasher. After removing the screws, lift and push the worktop forward to release the lugs from the front section of the dishwasher. The polystyrene block and the lugs should be saved for future use.
Power
Delay Start
1/2 Load
3in1IntensiveNormal Eco Rinse Glass Rapid
Remove
Remove
Remove
Unscrew
Stick the Condensation Strip under the worktop, where you want to install the dishwasher.
Leave some space
Failure to attach the condensation strip could result in damage to the underside of your worktop!
4. The condensation strip must be fitted to the underside of the worktop above your dishwasher to protect it against any moisture. Its purpose is to protect your worktop’s underside from steam rising from the dishwasher.
• Ensure the surface is clean prior to sticking
the condensation strip to the underside of the worktop.
• Remove the backing paper from the
condensation strip.
• Stick the condensation strip to the
underside of the worktop.
8
INSTALLATION
7. Make sure your plumbing is suitable for use with the dishwasher. If in doubt contact a qualified plumber. This unit MUST BE connected to COLD WATER MAINS using the new water inlet hose. OLD HOSE SETS MUST NOT BE RE-USED. The water pressure from the water mains needs to be at a minimum of
0.04 MPa and a maximum of 1.00MPa.
• Connect one end of the safety water
supply hose to your dishwasher, and then connect the other end of the hose to your water mains. Please ensure the black rubber seal is in place.
• After connecting the hose, turn on your
water mains and check for leaks.
• Connect the dishwasher to the mains
socket.
• Do not bend your drain hose.
water mains
safety water supply hose
Y-Adaptor
(not included)
Connect to another appliance if required.
You may use a Y-adaptor (not included) for an additional water feed for another appliance, for example a washing machine. This is only applicable for cold water mains. A Y-adaptor is available
from most DIY stores.
6. Position the dishwasher next to a water tap and a drain. Ensure the water inlet and drain hoses are not kinked or squashed. The unit must not stand on the mains cable.
Power
Delay Start
1/2 Load
3in1IntensiveNormal Eco Rinse Glass Rapid
9
INSTALLATION
water drain hose
U-shaped drain hose holder
• You may use the U-shaped drain hose holder to secure your drain hose and to avoid bending it.
• Secure the water drain hose to the waste pipe to avoid it coming off during the washing process.
• The waste pipe must only be connected to the foul drains and not the surface water drainage system.
• The water drain hose should be placed between 40 cm and 100 cm from the floor level and must not be extended, otherwise the unit may not be able to expel the waste water properly.
• Please close the hydrant after use.
10
Product Overview
Front View
Rear View
1. Control Panel
2. Door Handle
Power
Delay Start
1/2 Load
3in1 IntensiveNormal Eco Rinse Glass Rapid
2
3
1
5
4
3. Drain Hose
4. Water Inlet (Connect To Supply Hose)
5. Mains Cable (Connect To Electrical Mains Outlet)
11
Upper Basket
Internal View
Lower Basket
6
10
11
12
13 14 15 16
7
8
9
6. Upper Basket
7. Salt Reservoir
8. Lower Basket
9. Detergent Dispenser
10. Cup Rack
11. Spray Arm
12. Filter
13. Rinse Aid Reservoir
14. Salt Reservoir
15. Spray Arm
16. Filtering System
* All images are for reference only; please refer to your individual unit for actual item.
Loading...
+ 25 hidden pages