Logik LCH665SSE, LCH965SSE Instruction Manual

COOKER HOOD

LCH665SSE
LCH965SSE

DOMESTIC USE

INSTRUCTION MANUAL

Satety Warnings Operation Cleaning, Maintenance

and Troubleshooting

SpecificationBefore Use

GB-2

Safety

• The appliance must be installed according to the manufacturer’s instructions. Improper installation may result
in injury or damge, for which the manufacturer cannot be held responsible.

• The electrical safety of this appiance is guaranteed only if it is connected to a properly earthed system which
complies with the electrical safety standards in force. If you cannot verify that this fundamental safety requirement
is in place, consult a qualied electrician. The manufacturer cannot be held responsible for an appliance which has
not been correctly earthed.

• Check that the voltage (230VoltsAC) printed on the rating label inside the cooker hood corresponds to the
mains voltage in your home. If in doubt call a qualied electrician.

• Never replace the power supply cable yourself. Damaged cables must only be replaced by an authorised
service centre.

• Adaptors, multiple sockets and/or extension leads must not be used.

• To avoid electrical shock, never touch the cooker hood or plug with wet hands.

• Ventilation outlets on the cooker hood should never be covered, as obstructions may cause overheating or re.

• Always disconnect the plug from the mains supply before cleaning the cooker hood or carrying out
maintenance work.

• Do not ambé under the cooker hood as this may cause a re hazard.

• Avoid leaving a gas hob on when there is no pan on the stove.

• There should be adequate ventilation of the room when the cooker hood is used at the same time as
appliances burning gas or fuel.

• Regulations concerning the discharge of air have to be fullled.

WARNING!

It is hazardous for anyone other than authorised service personnel to carry out servicing or repairs which involves
the removal of covers.

To avoid the risk of an electric shock do not attempt to repair this appliance yourself.
If the supply cord is damaged it must be replaced by the manufacturer, its service agent , or similarly qualied
persons in order to avoid a hazard.

This appliance is not intended for use by persons (including children) with reduced sensory or mental capabilities, or
lack of experience and knowledge unless they have been given supervision or instruction concerning the use of the
appliance by a person responsible for their safety.

Children should be supervised to ensure that they do not play with the appliance.

Disposal

Old appliances still have some residual value. An environmentally friendly method of disposal will ensure that valu­able raw materials can be recovered and used again. Up to date information concerning options for disposing of
your old appliance and packaging from the new one can be obtained from your local council oce.

Satety WarningsOperationCleaning, Maintenance

and Troubleshooting

Specification Before Use

GB-3

Introducing Your New Cooker Hood

Before use

Please read these instructions carefully before using your new Logik Cooker Hood. The Cooker Hood is for indoor,
domestic use only.
WARNING: Please be carefully when unpacking and installing this appliance as sheet metal can cause injury if not
handled with care.

Telescopic chimney ue

120mm to 125mm ducting adaptor

Ducting adaptor

Cooker hood main body

Removable lters

Control panel

Screws ST4*35 X6 ST4*18 X4 ST4*10 X2

Washers x 2

Screw plug x 6

Install Your New Cooker Hood

Installation and electrical wiring must be carried out by a qualied engineer to ensure
all appliance codes and standards are followed. Before installing check that the
voltage indicated on the rating plate is suitable for your home.

Location

The Cooker Hood is designed to be a permanent xture in the home, therefore needs to be located in a place that
the lowest part of the hood will be set at least 70cm above the hob.
The Cooker Hood will need to be positioned with adequate ventilation directly over the cooker. The air that is
discharged from the Cooker Hood should NOT be ltered into a ue that is used for other appliances that use gas
or other fuels. Regulations concerning the discharge of air MUST be fullled.

IMPORTANT: The Cooker Hood ue MUST NOT be connected to a previously installed appliance i.e. water, heaters,
boilers or cooker. The Cooker Hood MUST have a separate ue and MUST NOT be installed above a cooker with
eye-level grills.

IMPORTANT: Easy access to the electrical socket must be maintained to ensure that you can carry out simple
maintenance.

Before plugging in YOU MUST

Check that you have a socket, which is compatible with the Cooker Hood.

Rating plate