Logik L17TKS13 Instruction Manual
GB-4 GB-5
Visit Partmaster.co.uk today for the easiest way to buy
electrical spares and accessories. With over 1 million
spares and accessories available we can deliver direct
to your door the very next day. Visit www.partmaster.co.uk or call 0844 800 3456 (UK
customers only). Calls charged at National Rate.
This symbol on the product or in the instructions means that your
electrical and electronic equipment should be disposed at the end of its
life separately from your household waste. There are separate collection
systems for recycling in the EU. For more information, please contact the
local authority or your retailer where you purchased the product.
IB-L17TKS13-131120V2
DSG Retail Ltd. (co. no. 504877)
Maylands Avenue, Hemel Hempstead, Herts., HP2 7TG, UK
CLEANING THE KETTLE
The kettle exterior should be cleaned with a soft damp cloth. Do not use abrasive
cleaners or scouring pads which may damage the nish of the kettle.
Never immerse the kettle or the stand in water and always keep the electrical
contacts dry. Always disconnect from the mains before cleaning the stand.
Do not insert any foreign objects or allow any liquid to spill into the
Power Connector Hole.
WHEN THE WATER HAS BOILED
The kettle will automatically switch o (indicated by the symbol ‘0’ ).
• Ensure that the switch is not
obstructed and the lid is rmly closed.
The kettle will not turn o if the
switch is obstructed or if the lid is
open.
• After removing the kettle, there may
be some water on the surface of the
stand. This is condensation from the
steam that causes the kettle to
automatically switch o after boiling.
This is normal and should not be a
cause for alarm.
DESCALING THE KETTLE
Depending on the hardness of the
water in your area, limescale may be
deposited on the heating element and
the inside of the kettle. This normal
build-up is not harmful to health but an
excessive amount of scale may aect
the performance of the kettle.
To descale, ll the kettle with distilled
water up to three-quarters of the Max
level and bring the water to boil. After
the kettle has switched o, add a
descaling solution following the
manufacturers instructions. Never
attempt to descale the kettle by
chipping or scraping with a sharp
implement.
SPECIFICATIONS
Mains supply: 220-240V~50Hz
Power consumption: 1850-2200W
We continually strive to improve our products. Specications may change without
prior notice.
Ensure the kettle is cool before removing the lter.
CLEANING THE REMOVABLE SCALE FILTER
To prevent loose particles of limescale being poured into your beverage, your kettle
is tted with a scale lter. You may remove the lter and t it back in after cleaning.
To remove the lter, open the lid, then push the lter out from the spout.
To ret the lter open the lid then push the lter back in place from the inside of the
kettle.
Instruction Manual
Traditional
Stainless Steel Kettle
L17TKS13
Thank you for purchasing your new Logik Kettle.
We recommend that you spend some time reading this instruction
manual in order to fully understand all the operational features it oers.
Read all the safety instructions carefully before use and keep this
instruction manual for future reference.
Power Connector Hole
Filter
L17TKS13_IB_RC_131120_Zell.pdf 1 20/11/13 4:51 PM
FILLING THE KETTLE
Open the lid and ll the kettle with the required
amount of water.
Do not exceed the maximum ll level (Max
1.7L) as indicated inside the kettle and not
less than the minimum ll level (Min 0.8L).
GB-1 GB-2 GB-3
SAFETY FIRST!
For your continued safety and to reduce the risk of injury or
electric shock, please follow all the safety precautions listed
below.
• Read all the instructions carefully before using this appliance and keep them for future reference.
• Retain the manual. If you pass the appliance on to a third
party, make sure to include this manual.
• Unplug the appliance from the mains socket when not in
use, or before cleaning any part of the appliance.
• Allow the appliance to completely cool down before cleaning.
• Never immerse the appliance in water and always keep the
electrical contacts dry.
• Never place the appliance on or near a source of heat such
as a cooker ring or gas ame.
• Always place the appliance on a dry, at and stable surface.
• Avoid contact with the steam from the appliance’s spout.
Take care when pouring or relling after boiling.
• To prevent from boiling dry, do not ll the appliance with
water less than the minimum ll level as indicated on the
appliance.
• Do not use the appliance to heat anything other than water.
• Do not interfere with the normal working of the switch.
• Always keep the appliance out of the reach of small children. Children should be taught about the dangers of boiling water.
• This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have
been given supervision or instructions concerning the use
of the appliance by a person responsible for their safety.
• Children should be supervised to ensure that they do not
play with the appliance.
• If the mains cable is damaged it must be replaced by the
manufacturer, its service agent, or similarly qualied
persons in order to avoid a hazard.
• Do not let the mains cable overhang the edge of the work
surface or allow it to touch hot surfaces or sources of heat or
ame.
• This appliance is intended to be used in households and
similar places such as:
- Sta kitchen areas in shops, oces and other work places.
- By clients in motels, hotels and Bed & Breakfast establish-
ments.
If the kettle is overlled,
boiling water may be
ejected from the spout
and cause scalding.
FIRST TIME USE
Clean your kettle by boiling a full kettle of water twice and then discarding the
water.
PRODUCT OVERVIEW
Lid
Handle
Kettle Stand
Mains Cable
Water Fill
Level
Spout
Place the kettle on its stand. Connect the stand’s
mains cable to the mains socket.
Push the power switch down to the ON position
(indicated by the symbol ‘I’).
SWITCHING ON
The kettle stand comes packaged
inside the kettle. Remove the kettle
stand and place it on a rm, stable
and dry work surface.
• Never open the lid while the water is boiling. The steam coming out
from the kettle is very hot.
• If there is insucient water in the kettle, the automatic safety cut-out
will operate. If this happens, allow the kettle to cool for ten minutes
before relling with cold water and re-boiling.
The power switch will light up.
UNPACKING
Remove all packaging from the unit. Retain the packaging. If you dispose of it please
do so according to local regulations.
The following items are included:
• The Main Unit • The Kettle Stand
* All images in this instruction manual are for indication only; please refer to your
individual unit
for details.
Power Switch
& Indicator
KEEPING THE MAINS CABLE TIDY
Extend the mains cable in the kettle stand
to the required length. Locate the mains
cable in the slot in the stand. For safety it is
recommended that the length of exposed
mains cable is kept as short as possible.
Slot
This kettle must only be used
with the stand provided.
L17TKS13_IB_RC_131120_Zell.pdf 2 20/11/13 4:51 PM
Loading...