Livex Lighting W008615515 Installation & Assembly

ASSEMBLING & INSTALLATION INSTRUCTIONS

The drawing shown may not exactly match the product enclosed.

However, the installation instructions do apply to this product.

 WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
 ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJ ON CTEUR.

ASSEMBLING THE FIXTURE (Fig.1)

1. Shut off the power at the circuit breaker box. Remove old fixture and all

2. By measuring, determine correct distance hole in mounting plate, then drilled

3. By measuring, determine correct cord length of needed for proper hanging

4. While holding the lamp body towards the ceiling, connect the electrical wires

5. Raise the lamp body onto the junction box, aligning the pipe thread on

6. Raise the outside lamp holder into the top ring of the shade(E, 6pcs), lock it

7. Install the light bulbs(Not included) in accordance with the fixture’s

8. Raise the center lamp holder frame insert the shade (C,1pc), aligning the end

Your installation is now complete. Return power to the junction box
the fixture.

hardware from Junction Box. Carefully unpack your new fixture and lay out all
the parts on a clear area. Take care not to lose any small parts necessary for
installation.

three holes(by measuring distance hole) in the ceiling at junction box of side;
raise the plastic anchor insert the hole. Attach the mounting plate to the
junction box with two junction box screws and three wood screws as shown,
tighten screws securely with the screwdriver. The side of the mounting plate
marked "GND" must face out. The junction box is not included. Attach the
canopy to the mounting plate, aligning the pipe thread with the small holes,
lock it securely with the hex nuts.

height, then lock it securely with small screw(B). NOTE: SLIDE WIRE CLIP

TO THE PROPER POSITION, THEN YOU MAY PROPERLY CUT THE
CORD IS TOO LONG PARTS. CONNECT THE ELECTRICAL WIRES AS

SHOWN IN FIG.2.
as Shown in Fig.2, making sure that all wire nuts are secured. You may have

to wrap the connections with electrical tape. If your outlet has a ground wire
(green or bare copper), connect the fixture ground wire to it. Otherwise
connect fixture’s ground wire directly to the Mounting strap with the green
screw provided. After wires are connected, tuck them carefully inside the
Junction Box.

mounting plate with mounting hole in canopy and lock it securely with the
round nut(B).

securely with the check ring until tight.
specifications. NOTE: DO NOT EXCEED THE SPECIFIED WATTAG!
bracket hole of the top shade with the top screw hole of the lamp holder frame,

lock it securely with the screws until tight. Using the same method install the
middle lamp holder frame and shade(D,3pcs).

FIG.1

Need assistance with parts or assembly? Please call customer service.

ALL RIGHTS RESERVED.

WoodScrew
BoxScrew

Canopy

Hexnut

Thank you for purchasing a product.

FIXTURE
WIRES
NO Lettering

Or White

Fig.2

FIXTURE
WIRES

Lettering

( L )

Or Black

( N )

FIXTURE
WIRES
Yellow
Thread

(Ground)

( )

Green or

Copper(Ground)

HOUSE
WIRES

Black
(Hot)

HOUSE
WIRES

White

(Neutral)

HOUSE
WIRES

Bare