Page 1
ASSEMBLING & INSTALLATION INSTRUCTIONS
The drawing shown may not exactly match the product enclosed.
However, the installation instructions do apply to this product.
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJ ON CTEUR.
49214 49216
ASSEMBLING THE FIXTURE (Fig.1)
1. Shut off the power at the circuit breaker box. Remove old fixture and all
hardware from Junction Box.
2. Carefully unpack your new fixture and lay out all the parts on a clear area.
Take care not to lose any small parts necessary for installation.
3. Raise the end of pipe thread (C) into the coupling, lock it with the hex nut
until tight. Raise the other end of pipe thread(C) into single bar (D), place
lock washer (B) over the end of thread protruding through single bar and
lock it securely with the hex nut (A).
4. Determine the desired hanging height. Slide the electrical wires through
the pipe thread(L)/tube(K)/tube(J)/(I)/(G)/ring(H)/canopy(F) and
assembled single bar(D).
5. Raise the pipe thread(L) to the center coupling of the lamp body(M), lock it
hex nut. Raise the tube(K) onto the lamp body, lock it with the tube(J),
raise the tube (I)/(G) and assembled single bar(D) to the screw pipe thread
in order, then by turning it clockwise until tight.
6. Install the light bulbs(Not included) in accordance with the fixture
specifications. NOTE: DO NOT EXCEED THE SPECIFIED WATTAGE!
7. While holding the assembled single bar(D) of fixture body to the ceiling
junction box with junction box screws (E) as shown, tighten screws
securely with screwdriver. The side of the single bar marked "GND" must
face out. The junction box is not included.
8. Connect the electrical wires as Shown in Fig.2, making sure that all wire
nuts are secured. You may have to wrap the connections with electrical
tape. If your outlet has a ground wire (green or bare copper), connect the
fixture ground wire to it. Otherwise connect fixture’s ground wire directly to
the single bar with the green screw provided. After wires are connected,
tuck them carefully inside the Junction Box.
9. Slide the canopy onto the Junction box, lock it securely with the ring(H)
until tight.
Your installation is now complete. Return power to the
junction box and test the fixture.
FIG.2 FIG.1
FIXTURE
WIRES
Black or
Smooth
HOUSE
WIRES
Black(Hot)
FIXTURE
WIRES
White or
Ribbed
HOUSE
WIRES
White
(Neutral)
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
Green or Bare
Copper(Ground)
Thank you for purchasing a LIVEX product.
Need assistance with parts or assembly? Please call customer service at: 800-761-8056
Or visit us online at: WWW.LIVEXLIGHTING.COM
©COPYRIGHT ALL RIGHTS RESERVED.LIVEX LIGHTING,INC. DOC20181149214
Loading...