Livex Lighting LVX3632 Installation & Assembly

Page 1
ASSEMBLING & INSTALLATION INSTRUCTIONS FOR PRODUCT# 5724 5725 5726
For mini Pendant Fixture
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER .
ASSEMBLING THE FIXTURE (Fig.1)
1. Shut off the power at the circuit breaker box. Remove old fixture and all hardware from Junction Box.
2. Carefully unpack your new fixture and lay out all the parts on a clear area. Take care not to lose any small parts necessary for installation.
4. Install the light bulbs in accordance with the fixture’s specifications. NOTE: DO NOT EXCEED THE SPECIFIED WATTAGE.
5. Attach the big ring(H) onto the glass shade(I),
to the
assembly
6. Thread the two studs (A) into the pre-drilled holes in the Mounting plate spaced the same distance apart as the holes in the canopy (B).
socket holder,
lock it securely with screw
Raise the
glass shade
until snug
(J)
Fig.1
.
7. Attach the Mounting plate to the Junction Box with the two Junction Box Screws as shown. The side of the Mounting plate marked "GND" must face out.
8. While holding the column assembly towards the ceiling , connect the electrical wires as Shown in Fig.2, making sure that all wire nuts are secured. You may have to wrap the connections with electrical tape. If your outlet has a ground wire (green or bare copper), connect the fixture ground wire to it. Otherwise connect fixture’s ground wire directly to the Mounting plate with the green screw provided. After wires are connected, tuck them carefully inside the Junction Box.
9. Put canopy (B) on to the outlet box, aligning screws on mounting plate with mounting holes in canopy and lock it securely with ball nut (C).
Your installation is now complete Return power to the junction box and test the fixture.
Fig.2
FIXTURE WIRES
Black or Smooth
HOUSE WIRES Black
(Hot)
FIXTURE WIRES White or Ribbed
HOUSE WIRES White
(Neutral)
FIXTURE WIRES Bare Copper
(Ground)
HOUSE WIRES Green or
Bare Copper(Ground)
U
L
R
Listed
R
Loading...