Livemix MT-1 User's Guide

POLE MOUNT

The Pole Mount conguration allows a CS-DUO to mount on a microphone
stand that is already being used on stage, reducing stage clutter and
eliminating the expense of purchasing dedicated stands for personal
mixers.

The MT-1 is compatible with pole diameters between 3/8” to 1 1/4”. This
allows the MT-1 to work with a wide variety of microphone, music and
percussion stands.

Before you begin, locate these features on the MT-1:

1. 2x Threaded knobs (1 3/4” length, 1/4” - 20 thread)

2. 1x Removable V-Clamp piece

MT-1 USER GUIDE

MT-1-1 rev 1.0

3. 2x Captive thumbscrews (thread into CS-DUO)

To attach the MT-1 and CS-DUO to your mic/music stand pole:

1. Loosen the threaded knobs to the point where the V-Clamp can swing
freely.

2. Insert the mic/music stand pole between the V-Clamp and the back of
the MT-1.

3. Tighten the threaded knobs evenly until the MT-1 is fastened tightly to
the pole.

4. While holding the CS-DUO, slide the CS-DUO down the mount so the
back wall of the CS-DUO catches the alignment surface of the MT-1.

5. Still holding the CS-DUO, center it on the MT-1 and thread the thumbscrews into the CS-DUO by hand.
If permanent attachment is desired, the thumbscrews can also accommodate Flathead and Phillips
screwdrivers.

6. Route cables through cable management openings.

THREAD MOUNT

The Mic Stand Thread Mount conguration allows a CS­DUO to mount on a dedicated microphone stand. This
mounting method is perfect for musicians that don’t
require other stands for microphones or music.

Four captive thread holes on the bottom side of the CS­DUO allow the personal mixer to mount in two different

positions on the MT-1.

Before you begin, locate these parts of the MT-1:

1. Large circle opening on the bottom side of the
mount

2. 1x 5/8” - 27 nut (secured to MT-1 with V-Clamp
screw.

3. 2x Captive thumbscrews (thread into CS-DUO)

To attach the MT-1 and CS-DUO to your mic stand:

1. Align the large circle opening on the bottom side of the
MT-1 with the top of the microphone stand.

2. Secure the MT-1 by threading the 5/8” - 27 nut until it is
nger tight.

3. To rmly lock the MT-1 in place, hold the microphone
stand pole with one hand while turning the MT-1 with the
other hand.

4. Locate the two captive thread holes on the bottom side
of the CS-DUO personal mixer that are closest to the
front panel. These are the recommended mounting
connections on the CS-DUO for this conguration.

5. While holding the CS-DUO, align the MT-1 captive
thumbscrews with the CS-DUO captive thread holes
mentioned in step 4.

6. Still holding the CS-DUO, thread the thumbscrews into
the CS-DUO by hand. If permanent attachment is desired, the thumbscrews can also
accommodate Flathead and Phillips screwdrivers.

7. Route cables through cable management openings.

© 2013 DIGITAL AUDIO LABS.
Subject to change without notice.

DIGITAL AUDIO LABS

1266 PARK RD

CHANHASSEN, MN 55317

WWW.DIGITALAUDIO.COM

[e-mail]

(952) 401 - 7700