LITE ON TECHNOLOGY WN6508A User Manual

880022..1111 aa//bb//gg//nn,, 22..44GG//55GG 33TT33RR WWiirreelleessss MMoodduullee

WNN66550088AA

W

Usseerr

U

’

Maannuuaall

’

ss M

Kaysa Lee Page 1 6/25/2012

REGULATORY STATEMENTS
FCC Certification

The United States Federal Communication Commission (FCC) and the Canadian
Department of Communications have established certain rules governing the use of
electronic equipment.
Part15, Class B
This device complies with Part 15 of FCC rules. Operation is subject to the
following two conditions:

1) This device may not cause harmful interference, and

2) This device must accept any interference received, including interference

that may cause undesired operation. This equipment has been tested and found to
comply with the limits for a Class B digital device, pursuant to Part15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and can radiate
radio frequency energy, and if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning
off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Kaysa Lee Page 2 6/25/2012

Warning: Changes or modifications to this unit not expressly approved by
the party responsible for compliance could void the user authority to operate
the equipment.

1. This Transmitter must not be co-located or operating in conjunction with

any other antenna or transmitter.

2. For product available in the USA market, only channel 1~11 can be

operated. Selection of other channels is not possible.

IMPORTANT NOTE:

This module is intended for OEM integrator. The OEM integrator is still responsible
for the FCC compliance requirement of the end product, which integrates this module.

20cm minimum distance has to be able to be maintained between the antenna and the
users for the host this module is integrated into. Under such configuration, the FCC
radiation exposure limits set forth for an population/uncontrolled environment can be
satisfied.

Any changes or modifications not expressly approved by the manufacturer
could void the user's authority to operate this equipment.

The operation frequency of the device is in the 5150-5250 MHz band is for indoor use only. A

warning message should be provided in the user’s manual.

Kaysa Lee Page 3 6/25/2012