LITE ON TECHNOLOGY AAT02P User Manual
Antenna Alignment To
ol
Download free at:
C
harge Your Equipment
D
ownload APP (BlueSPP) and Install It In Your Smart Phone.
1a.
1a.
plug in adaptor
1a.1a.
1b.
1b.
charging: LED is ON
1b.1b.
1c.
1c.
charging done: LED goes OFF
1c.1c.
Note:
Note:
Note: Note:
Step2 to step5 could be
executed when the device is
in charging.
Note:
Note:
Note: Note:
BlueSPP is now ready
for Android system only.
Agree to Terms & Conditions
E
nable Bluetooth Settings and
Power on Device
Take a Picture
Issue Command
Settings
Bluetooth
On
P
airing AAT Bluetooth
4a.
4a.
pair AAT Bluetooth
4a.4a.
4b.
4b.
enable APP (BlueSPP)
4b.4b.
4c.
4c.
setup BT connection
4c.4c.
5a.
5a.
issue command <7,0 > on APP
5a.5a.
5b.
5b.
get the finish message on APP
5b.5b.
5555cccc....
confirm the photo download on phone.
5555dddd....
go to “
bluetooth folder
The contents of this document should not be disclosed to unauthorized persons without the written consent of LITE-ON.
Customer Satisfaction••••Excellence in Execution••••Innovation••••Integrity
Check Photo
” to check photo.
Rev. 28-11-2018
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC Caution
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Non-modification Statement:
Changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.
RF warning statement:
The device has been evaluated to meet general RF exposure requirement. The device can be used in fixed/mobile
exposure condition without restriction.
Loading...