Lionel Operating Horse Car and Corral Owner's Manual

73-6855-250

6/08

Lionel

Operating Horse Car

and Corral

Owner’s Manual

Congratulations!

C

ongratulations on your purchase of the Lionel Operating Horse Car and Corral! This
animated car features horse figures that travel through the car and into the corral.

The OTC Contactor (included) was designed for use with traditional O and O-27
gauge track only. For FasTrack layouts, use O Gauge Transition sections (available
separately, 6-12040) to join the track with a traditional O gauge track section.

2

Note!

The following Lionel marks may be used throughout this instruction manual and are protected under law. All
rights reserved.

Lionel®, TrainMaster®, Odyssey®, RailSounds®, CrewTalk™, TowerCom™, DynaChuff™, StationSounds™,
Pullmor®, ElectroCoupler™, Magne-Traction®, CAB-1® Remote Controller, PowerMaster®, Lionel
ZW®, ZW®, PowerHouse®, TMCC®, Lionelville™, Lockon®, Wireless Tether™, LionMaster®, FatBoy™,
American Flyer®, TrainSounds™, PowerMax™, LEGACY™, PowerMax™ Plus

The name FasTrack® is used with permission from Pitsco, Inc.

Table of contents

Setting up the Corral and OTC Contactor 4-7

Wiring your Corral and OTC Contactor 8

Operating the Horse Car and Corral 9

Adjusting the Horse Car doors 10

Notes 11

Limited Warranty/Lionel Service 12

3

4

Figure 1. Installing the corral feet

Setting up the Corral and OTC Contactor

F

ollow these steps to set up the corral and OTC Contactor.

For FasTrack layouts, use O Gauge Transition sections (available separately, 6-

12040) to join your track to a traditional O gauge track section for use with the OTC
Contactor.

1. Be sure to install the rubber feet on the bottom of the corral. The shorter end of the feet
should be exposed for O-27 gauge layouts; the taller ends should be exposed for O gauge
layouts. As illustrated in Figure 1, use a nail or a screwdriver inserted into the holes to help
you position the feet.

For O gauge track

For O-27 gauge track

Note!