Lionel Oil Pump Owner's Manual

73-4162-250

9/04

Lionel

Oil Pump

Owner’s Manual

C

ongratulations on your purchase of the Lionel Oil Pump! Based on the “nodding donkey”

style pump working oil fields across the country, this new accessory features the smooth
bobbing action of the real thing. You may choose to add another pump or two to model a large
oil field.

2

Congratulations!

Table of contents

Installing the accessory 3-4

Operating the accessory 4

Controlling the accessory in the Command Control environment 5-6

Notes 7

Limited Warranty/Lionel Service 8

Inventory of parts

• Oil Pump accessory

• Three green wires

• Separate ON/OFF switch

The following Lionel marks may be used throughout this instruction manual and are protected under law.
All rights reserved.

Lionel

®

, TrainMaster®, Odyssey®, RailSounds®, CrewTalk™, TowerCom™, DynaChuff™,

StationSounds

™

, Pullmor®, ElectroCoupler™, Magne-Traction®, CAB-1®Remote Controller,

PowerMaster

®

, Lionel ZW®, ZW®, PowerHouse®, TMCC®, Lionelville™, Lockon®, Wireless Tether™,

LionMaster

®

The name FasTrack®is used with permission from Pitsco, Inc.

Installing the accessory

T

his accessory operates best at 12-18 volts (AC). You may choose to supply power with a separate

accessory power supply or through the track using a Lionel Lockon (available separately,
6-62900) or a FasTrack Accessory Power Wire (available separately, 6-12053). Refer to Figure 1 on
page 4. To make the proper connections, the ends of the wires must be stripped back 1/8” to 1/4”.

Only an adult should perform this task. We recommend using a pair of wire
strippers. Always use care when stripping wires.

1. Attach one wire to a terminal on the underside of the accessory and connect it to the

Power/A terminal on your power supply or to the #1 Lockon terminal. If you are using the
FasTrack Accessory Power Wire, twist the accessory wire to the Accessory Power Wire, which must
be attached to the track. We recommend using a wire nut to insulate this connection.

To make the spring clip terminal connection, press down on the top portion of the
spring clip so that the metal loop is exposed. Slide the bare end of the wire into the
loop, then release pressure on the spring clip.

2. Attach another wire to the remaining accessory terminal and connect it to the separate

switch.

To make the switch connection, loosen the screw, wrap the wire around the screw
clockwise, and tighten the screw to secure the connection.

3. Attach a final wire to the separate switch and connect it to the Common/Ground/U terminal

on the power supply or the #2 terminal on the Lionel Lockon. FasTrack users, twist the end
of the wire to the remaining Accessory Power Wire and insulate the connection.

Caution!

3

Note!

Note!